HauffMachineProducts's channel
Loading...
15
subscribers
68,022
video views
Uploaded videos
1-10 of 12-
Early Knucklehead Muffler Manufacturing
HauffMachineProducts
193 views
This video is showing one of the many steps in manufacturing mufflers for the early Knuckleheads. We are crimping the reducer on to the outer can flange in this step. Matt ...
-
Doosan MX2500LST Machining Bearing Cage for Carl's Cycle Supply
HauffMachineProducts
276 views
Dry running a Knucklehead crankshaft bearing cage for Carl's Cycle Supply. Feed speeds are 2-4 times what I will be running in heat treated steel. Every feature is machined...
-
2010 Motorcycle Cannonball Katrin and Dieter starting their bikes
HauffMachineProducts
429 views
This is a couple from Germany push starting their bikes. Katrin is riding a 1907 single speed JAP and Dieter is riding a single speed 1913 BSA. Neither bike has so much as ...
-
Hauling rock with Screaming Detroit 6v92
HauffMachineProducts
23,078 views
I am working on my brother in law's road with my ol' Ford l9000. Today we are hauling in rock to rip wrap the road. Just a short clip of the 6v92 Detroit at work.
-
Screaming Detroit
HauffMachineProducts
17,317 views
I am building up my brother in laws road with the Help of Lepp Construction. They brought in a lot of heavy equipment including the Michigan L320 that loaded this truck. Wh...
-
Starting Matt Olsen's 1914 Sears Cannonball Bike for the first time.
HauffMachineProducts
718 views
This is a video showing the break-in process before startup of the Sears. This takes place at Carl's Cycle in South Dakota. We made quite a few parts for this bike in our s...
-
6V92T Detroit and 10spd Fuller Freight Shaker for Hauff Machine Products
HauffMachineProducts
8,608 views
I am out for a test run in my new truck. A few missed shifts but not bad for just learning on a Fuller 10 speed. It is a lot easier to shift than a Mack Tri-plex. Enjoy the...
-
Hauff Machine Huff and Puff Engine
HauffMachineProducts
301 views
This is a short video to our little Huff and Puff engine running. I am running it on compressed air. Sorry for the poor quality, my camera does not do well on close up video.
-
Doosan 9 Axis Multi-task Machining Center Making a Flywheel at Hauff Machine Products
HauffMachineProducts
4,960 views
We are machining a flywheel for a Huff & Puff engine on a Doosan MX2500LST multi-task machining center. The spokes are machined by interpolating the X and C axis. Notice ho...
-
Miniature Steam Engine Cylinder made on Doosan at Hauff Machine Products
HauffMachineProducts
804 views
This engine cylinder is being machined on a Doosan MX2500LST multi-tasking center at Hauff Machine Products. This engine is powered by blowing into a mouth piece on the sid...
Advertisement
About HauffMachineProducts's channel
more
less
Play all(12)