Damadarfury's Channel

29 subscribers

2,649 video views

5:59

5 days ago

SS SSG Demo showing the basics - 26th Febuary 2012.AVI

This is a clip of my SS SSG. The coil is 5 strands of 150 ft lengths of litz copper wire, 4 x 0.56mm and 1 x 0.4mm. Thus far tuning is not complete...

11 views

Damadarfury uploaded
41:37

6 days ago

High Voltage Without DC Power Supply II

This is a follow up video to better explain the first one.

Some have asked for the part numbers on the motors I use:

Larger 3" Diameter

AX060188B

...

DadHav • 191,563 views

Damadarfury liked
- 6 days ago
  
  Damadarfury commented:
  
  Hey John,
  
  I'm making some coil mounts now so can run a gen coil with the seperate SSG circuit hooked to a light in parallel with a cap. I seen that if you split the bifilar coil and offset the trigger you obtain a larger spike from the induction of the collapsing field.
  
  My question is did you add...
7:02

1 week ago

Bedini Monopole SSG Timing

This video shows that when the Bedini Monopole SSG is tuned so the coil discharges occurs at the mid-point between 2 magnets, the highest RPM is ac...

koornj • 146 views

Damadarfury commented:

Thanks for the demo John and I see what size pot you are tuning with. I missed out when I visited mate, the 10 coiler looks great in the shed. Were you running that 24V on the front and back for the clip?

Dan.
5:38

1 week ago

Half Bipolar Circuit Mod on the TWM - 24th Febuary 2012.AVI

A clip to show how to convert the Tiny Window Motor (TWM) circuit to a half bipolar circuit onto a proto board with 4 leads bypassing the SSG circu...

110 views

Damadarfury uploaded
- 1 week ago
  
  Damadarfury commented:
  
  @picturen8 Thanks buddy. Is very easy to try with a standard SSG circuit, unless you hooked the coil up backwards to trigger the south pole to switch. Or the maybe the scalar/imaginary south pole my still switch the transistor.
  
  The TWM has a stator with a N-S-N-S-N-S config.
  
  Ideally I just want ...
3:07

1 week ago

Joule Thief Light Show

Nothing extraordinary going on here, just a simple joule thief circuit, but with a 3 color LED in place of the white or blue LED.

I read you could ...

picturen8 • 46 views

Damadarfury commented:

"Spike" lol not skipe:)
25:56

2 weeks ago

Bedini SSG - The Culmination

Here are some high points, there is much more to consider, this is my interpretation of the icing on the cake.

Think balance -- everything has to b...

min2oly • 714 views

Damadarfury commented:

Hey Patrick,

Very impressive. Do you believe back popping the primary via a cap dump is recovering more energy than just shorting the coil?

Regards

Dan.
17:20

1 month ago

Grind Time Now Aust: Massacre of Melburn - Dirtbag Dan vs 360

A highly anticipated battle at The Massacre of Melburn between San Jose's heavyweight Dirtbag Dan and Australia's own killer 360.

Held at the Laun...

GrindTimeNowAust • 104,701 views

Damadarfury liked
19:47

1 month ago

GTNA Best Of Both Worlds - 360 vs Kerser

The biggest match up in Australian battle rap for 2011. Campbelltown's Kerser goes toe to toe with Melbourne's 360 to settle the hype between their...

GrindTimeNowAust • 962,173 views

Damadarfury liked
13:20

1 month ago

GOT BEEF? - From The Ground Up - 360 vs Keynote

This is an intense battle from our 'From The Ground Up Event'. 360's battle tactics in round 3 are second to none!

gotbeefbattles • 370,244 views

Damadarfury liked
17:19

1 month ago

GOT BEEF? - War Of The Worlds - 360 & Anecdote vs Real Deal & Fresco

Real Deal and Fresco make the trip up to have an entertaining battle against Anecdote and 360.

gotbeefbattles • 108,377 views

Damadarfury liked
14:49

3 months ago

Bedini Joule Thief

Lasersaber's addition of the diode to the base of the transistor. the twist is that we have added it to John Bedini's SS SSG.

min2oly • 1,144 views

Damadarfury commented:

Hey Patrick, Great work as usual and like many the SS SSG circuit hooked up to a solar panel is calling me:) Will post up on BM2 when obtain a result. I have been having fun with solar garden light joule thief circuit and this seemed like the natrual progression.

Regards

Dan
- 3 months ago
  
  Damadarfury liked
3:21

4 months ago

Testing RC Components to Run a Kromrey Converter - 26th October 2011.AVI

Just a quick experiment I constructed to see if I could use a large flooded cell battery or a PSU in place of the Li-Po/Ni-Mh packs containing cell...

186 views

Damadarfury uploaded
22:29

4 months ago

ENERGY EVERYWHERE !!

HV voltage tester beeping on everything! What a surprise. All of a sudden everything connected to the project would set off a voltage sensing pen t...

DadHav • 4,496 views

Damadarfury liked
- 4 months ago
  
  Damadarfury commented:
  
  @DadHav I have seen it myself on a SS SSG circuit and even was lighting the neon grounded in my hand and other end on the plastic of the battery. I can only assume is RE as JB has said and is the Heaviside flow coupling with that RE and thus in some set-ups is the anomolous energy output on the w...
3:32

4 months ago

Hobby King Wing Camera on an FMS Spitfire 1400

A video taken with the Hobby King wing camera that I mounted on the wing on my FMS Spitfire. It was late in the afternoon and as a result the camer...

SJohnM81 • 76 views

Damadarfury commented:

Hey Steve, Nice work with taping the mini camera to the wing, lol. That was cruising over the lake much clearer clip recording on the wing.

I have on order a G46 brushless motor and the rest of the gear we talked about to run the KC. I will bring it up in a month or so when have all the parts he...
9:18

5 months ago

OTG - a Bedini Kromrey Converter replication Assembly Part 1 low quality

First time the finished bits for our replication of John C Bedini's kromrey Converter have been pieced together and thought I'd video it as a test ...

DaveMichaelRogers1 • 5,664 views

Damadarfury liked
5:37

5 months ago

Dual Toroid Project and Frozen Crystal Cell Update

This video is to show the Encapsulation for the Modified Lasersaber variant oscillator circuit, as well as to show the extended time the circuit co...

diveflyfish • 188 views

Damadarfury subscribed to diveflyfish
4:43

5 months ago

CR-OCTO KROMREY SYNC.mov

THIS IS A BRIEF CLIP SHOWING BOTH SIDES OF THE COUNTER ROTATING KROMREY RUNNING. SYNERGY EXISTS WITH BOTH SPINNING, OPTIMIZED BY SYNCHRONIZATION. ...

diveflyfish • 74 views

Damadarfury liked
7:59

5 months ago

Muller Motor Driven by Out Runner to 8000 RPM

Here is the on going work to achieve a working Muller motor generator.

We now have a good working RPM range for the research.

toranarod • 886 views

Damadarfury liked
2:13

5 months ago

BM3 Spec SSG Charging Trojan 6V 420AH Battery .AVI

This is the latest SSG I have charging the Trojan batteries. The SSG is a 26 inch Aluminum rim, stainless spokes bikewheel. (all non-magnetic) It h...

218 views

Damadarfury uploaded
6:27

5 months ago

6 filar solid state 2.AVI

This is an update to my previous video about J.B Solid State Energizer. Same circuit except that I removed the diodes between collectors and emitt...

blackchisel97 • 695 views

Damadarfury commented:

Great presentation Vtech and I like the variable charging due to switching on the base resistors to the transistors depending on the desired load.

Dan.
2:47

5 months ago

Tesla Impulse Technology on SSG Circuit Demo.AVI

An easy modifacation to a Bedini SSG circuit that a started playing around with on the 29th June 2011, after I watched "Energy From The Vacuum 7".

...

373 views

Damadarfury uploaded
- 5 months ago
  
  Damadarfury commented:
  
  @GeorgeyNico and I did not use 1N4007 diodes for the bridge due to the voltage drop and losses, compared to the 800V/35A (CM3504) bridge rectifier I had on hand. Did try 8 different FWBR's and that was the lowest VD and obtained the highest charging rates, plus voltage peaks on the DSO.
  
  Dan.
2:35

5 months ago

Tiny Window Motor (TWM) Demo showing RPM vs Current Draw

Just a quick demo to show the Tiny Window Motor (TWM) that I obtained with a standard SSG circuit. This will be swapped out to a Bedini-Cole Bipola...

375 views

Damadarfury uploaded
- 5 months ago
  
  Damadarfury commented:
  
  I actually obtained the kit through John K's store Wavelength Energy Solutions vis R-charge and did forget to mention that and thankyou mate:)
  
  Dan.
22:57

5 months ago

Lead Acid Alum Battery Conversion Part2.wmv

Alum Battery Conversion Part 2,

This is a converted Ford Mustang Battery 590 cold cranking amps that is about 30 Amp Hr battery. Testing on a batt...

Energenx • 355 views

Damadarfury subscribed to Energenx
5:01

6 months ago

16 Pole Superpole 2 Coils

Bedini SSG Monopole Superpole. 2 Coils, 11 SSG circuits.

koornj • 1,016 views

Damadarfury commented:

@koornj Great work John and was this set to 2 PPM later on or was the single PPM (reasonance) the best charging rates? Also, did you solve what the spikes were on the scope with the primary was disconnected?

Dan.
- 6 months ago
  
  Damadarfury liked
2:21

6 months ago

Faraday

Easy Faraday Motor

koornj • 350 views

Damadarfury liked
- 6 months ago
  
  Damadarfury commented:
  
  This works due to the magnetic particles are in a constant state of flux, watch the contact between the 2 magnets, the N-S pressed together. This is the bloch wall that allows a path for the magnetic particles to flow along the wire. Clearly, this demo shows when you reverse the polarity on the m...
1:56

6 months ago

Dan's Bedini SSG Half Bipolar Circuit Minus Hall Switch - Demo.AVI

Added a Half bipolar circuit, minus the hall effect sensor switch to my SSG

circuit. I just bypassed the SSG circuit on the terminal blocks, then ...

555 views

Damadarfury commented:

Run out of room, will try switching when I obtain the mindow motor. You have me thinking now can just use a single hall to switch the nth pole, but with no secondary power winding, will this impact a monopole?

Thanks for watching Patrick and I will post the charging battery clip when I record it ...
8:56

6 months ago

Crystal cell holding after 1 week

min2oly • 303 views

Damadarfury commented:

Hey Patrick,

There sure is a relationship between the temperature in the cells vs voltage production.

Now to heat a plate to add under the cell and then the data should be much clearer,

with a rise and fall curve for voltage over time.

Nice clip I'm still a fan:)

Cheers

Dan
8:12

6 months ago

Renaissance' Smallest Magnetic Window Motor Kit

Running the little energizer at 10,000 RPM while charging a battery and CFL

rickfriedrich • 3,354 views

Damadarfury liked
- 6 months ago
  
  Damadarfury commented:
  
  Great work Rick and I'm looking forward to using mine when it arrives in Australia.
  
  I will have to use a DPDT switch to swap between the SSG circuit and the bipolar circuit since is a N-S-N-S-N-S magnet arrangement on the rotor.
1:56

6 months ago

Dan's Bedini SSG Half Bipolar Circuit Minus Hall Switch - Demo.AVI

Added a Half bipolar circuit, minus the hall effect sensor switch to my SSG

circuit. I just bypassed the SSG circuit on the terminal blocks, then ...

555 views

Damadarfury uploaded
28:38

6 months ago

Sniffing Out Free Energy

This video was made to show the use of a simple sniffer coil to see what might be taking place on the the plates of a battery as it gets charged fr...

DadHav • 563 views

Damadarfury subscribed to DadHav
12:24

6 months ago

John Bedini findings on Hutchison cell 9 August 2011.wmv

John Bedini talks about his findings on these cells.

woodchuckh • 2,004 views

Damadarfury commented:

Thankyou for posting this clip and that is the question, how do these things perform

under load and what is the duration the materials will retain charge?

This answers the questions I had on the performance of the cell and can you

increase efficiency via the materials interaction.

Regards

Dan
1:53

6 months ago

Tuning Bedini SSG with a DSO to obtain a single PPM.

Just a quick clip of my SSG tuned to 1 pulse per magnet (PPM).

Is stopped and restarted to see the time it takes on the DSO to

tune to a single PPM...

151 views

Damadarfury commented:

@denniserhodesThanks mate, max speed is 3800 rpm at 240mA. I could change the GOW to a 9 Ohm version

and then take base resistance down to 10 Ohms, would increase further.

I still need to cut the plastic for my new spool to match the dimensions of the master coil.

Have the circuit soldered, plus ...

About Damadarfury's channel

Created by

Damadarfury

Latest Activity

Feb 28, 2012

Date Joined

Jun 26, 2011

Age

Country

Australia

less