Uploaded videos
1-10 of 21-
Hertz HSK165XL
CoupeDeville23
2,001 views
Just a quick vid of the Hertz HSK 165XL in action during installation. System is active, with no rear speakers, and all four channels of an Alpine PDX-4.100 going straight...
-
JL Audio 12w6v2
CoupeDeville23
713 views
Just finished installing my new JL Audio 12w6v2s and the C5-650 6.5" components... Experimenting with a 60hz HPF/LPF setting...
System: Alpine CDA-9886 HU, JL Audio C5 6.5...
-
JL Audio C5-650 components
CoupeDeville23
1,245 views
JL Audio 6.5" C5 components running off an Alpine PDX-4.100, getting 127 watts RMS power.
Settings: HU ... Bass+2, Treble-0, HPF-80hz, Q3 bandwidth
XOver settings: Midra...
-
JL Audio 13w7
CoupeDeville23
1,502 views
13.5" JL Audio w7 subwoofer in a spec built 2.375 cubic ported enclosure, powered by a JL 1000/1v2. Q-bandwidth-0.8, center frequency-45hz, bass boost-+4, 12db slope, subso...
-
JL Audio 13w7 & 1000/1v2
CoupeDeville23
5,279 views
JL 13w7 powered by a 1000/1v2 @ 3ohms. Settings on HU; volume 24 out of 35, bass-0, treble-+1, Fader-Front+7, HPF-80hz.
Settings on 1000/1; LPF-85hz, Center Frequency 48h...
-
JL Audio 13w7
CoupeDeville23
1,125 views
Demo of the even response of the w7 subwoofer. Typical subwoofers in this type of enclosure are overly heavy on low-end response, and the punchier upper end frequencies are...
-
JL Audio 13w7 & 1000/1v2
CoupeDeville23
3,375 views
JL Audio 13.5" w7 subwoofer, 2.375 cubic ported avpriority enclosure (built to spec), JL Audio Slash 1000/1v2 amplifier (1/3rd gain, 54.7 volts, 3ohm load), Alpine CDA-9886...
-
JL 13w7 & 1000/1v2
CoupeDeville23
1,102 views
JL Audio 13w7, in a spec built ported box, powered by a JL Slash 1000/1v2. Gain set to 53.4 volts (only 1/3rd), Bass Boost +4, Center frequency 45hz, Q bandwidth of 1.0, 12...
-
JL 10w7 HO 1000/1v2
CoupeDeville23
1,138 views
JL 10w7 High Output - JL 1000/1v2. Infinity Kappa speakers, Alpine PDX-4.100 amp, Alpine CDA-9886 HU, big 3 upgrade, stock electrical, full dynamat (70 sq. ft) on 95' Camry.
-
JL 10w7 HO 1000/1v2
CoupeDeville23
714 views
10" JL Audio w7 subwoofer, mounted in the JL High Output enclosure, powered by a JL 1000/1v2 @ 3 ohms. Infinity Kappa 3 ways all around, powered by an Alpine PDX-4.100. 70 ...
Advertisement










Play all(21)