Centurion Systems
Loading...
24
subscribers
25,527
video views
Uploaded videos
1-10 of 37-
CENTURION_VECTOR_Installation.wmv
CenturionSystems
115 views
Full installation of Vector swing gate actuator
-
Centurion D5 and D3 installation SD.mpg.wmv
CenturionSystems
117 views
CENTURION D5 and D3 sliders full installation video
-
Part 8 - Remote Controls - CENTURION - D5 and D3 installation
CenturionSystems
200 views
For more information visit http://www.centsys.co.za
CENTURION - D5 and D3 installation Part 8 Remote Controls
-
Centurion Vector Swing Gate Motor Installation Part 6 Setting the Gate Limits - Official video.wmv
CenturionSystems
95 views
Instructions for setting the gate limits on the Vector swing gate operator
-
Centurion D5 and D3 Sliding Gate Motors installation - Introduction.wmv
CenturionSystems
229 views
Introduction to D3 and D5 sliding gate operator installation
-
D2 Turbo motor assembly attachment
CenturionSystems
55 views
How to detach the D2 Turbo motor assembly from the gearbox, and reattach it again
-
D10 TURBO High Speed Industrial Gate Motor
CenturionSystems
1,125 views
A short clip having a look at CENTURION's fastest gate motor yet. It runs at speeds up to 50m/min - which in gate automation is incredubly quick.
-
CENTURION D2 Turbo - changing from High to Low speed setting
CenturionSystems
210 views
The D2 Turbo runs at 24m/min by default - which is turbo-quick in gate automation terms! You can slow it down and change it to run at 16m/min in mere seconds. Check it out.
-
CENTURION D2 Turbo - Autoclose setup
CenturionSystems
181 views
Autoclose Mode - it's set up in seconds. Take a look how quick this is. Of course you'd need to have gate safety infrared beams installed too.
-
CENTURION D2 Turbo - Learning in remote controls
CenturionSystems
444 views
A quick demo to illustrate how easy it is to learn in a remote control with a D2 Turbo controller.
Play all(37)