Bigwingrider1800's channel

This clip shows a classic operation in watchmaking training: the creation of a school watch.

First Cuts.

How to make a useful tool in the lathe. drilling tapping and grinding skills.

A larger version of this tool is used in full size car engine head ma...

The garage early days (so much has changed since this video) I got the tormach so i can build a larger router. Need a video camera this phone sucks...

Started working on the router again. All axis are mounted now and moving good. I have all the bearings now im looking at ball screws for all 3. Im...

tormach 770 cutting the dragon finish pass.Im using my phone and kinda new at this so get from it what you can......peace

CUTTING THE DRAGON ON MY TORMACH 770 THIS IS A ROUGH PASS.

I got this jpeg off the net.Put it in cad and did a 2-d profile. turned it into a solid by extruding the profile then i cut it turned out great.

This is how i set the distance rail to rail.I tried useing the numbers from cad but found it needed a bit more so i folded some thick paper 2x and ...

pilot holes machined with 770

Drilling and tapping with dewalt hand drill.

How i drilled and tapped the ends of the 60" side rails. I did the layout from cad center punched the cross marks. Then drilled a small hole .140 m...

This is a short video of my Lever Operated Drawbar for the Tormach PCNC1100 milling machine. More information and plans are available at www.sdmfab...