Beeilly's channel

@SkatingIsMyWayOfLife

Thats because for had shitty sales for the four years before things got bad. For was prepared because, you guessed it no sales.

The H3 has the same motor and drive train as the Colorado, but the frame is not unibody construction it has a fully boxed frame, they are not as fraile as everyone claims. Mine will go through some pretty rough shit, but I am not an idiot only someone that has no brans would do that to a 4,500 p...

Just bought me a 2006 h3, I was fixing to do a break job for someone. He is a younger fella, said he wanted his torsion bars tightened maybe one inch lift, I told him while we are at it we can lift the hummer about an inch to inch and a half, two inches or more will wear your cv joints badly.

FIat can eat shit out of a bucket. I hate you for what you have done to American cars.

I work 75-80 hours a week and still have time for my family, your little pissy job all week could not amount to one day at my job. So grow up a little then see how your viewpoint changes.

sounds good to me, is that tuned down a half step? I know how to play quite a few of AC/DC songs but sadly tbey are not from the Bonnie era, learned a few but not many, nightprowler is my absolute favorite. AC/DC is all i listen to, not kidding ALL I LISTEN TO.

@BadMagick29

No shit got my right forearm covered, about six hours, my first tattoo, on the soft part of my forearm. SLEEPING was the last thing on my got damn mind.

What alloy wire is being used???

@JunkyMcSnot

I could send you a video of me pulse welding alum. I have a Daihen DP400. Look it up. Send me your E-mail address. Not being an ass just letting you know. The place where I work is using cutting edge technology. Seriously. Very nice welds on .075 aluminum no bleed through on ...

Very good weld alot of people commenting are used to cosmetic alum welding not strength. I use 5356, 3/32 wire for 1/4, 3/8 aluminum. In my experience that is probably one of the best welds on thick alum i have seen. It is very hard to get rid of the smoke on thicker aluminum. Rookie comments...

Hope all goes well freind.