AtienzaLouie's channel
Loading...
205
subscribers
183,896
video views
Uploaded videos
1-10 of 63-
DIY CNC Router, Aluminum Milling High Speed Motion
AtienzaLouie
85 views
Using OneCNC's high-speed toolpaths to make my home-made CNC run at a greater capacity and speed than it normally would using traditional toolpaths. The tool actually retr...
-
GeckoDrive G540 Installed in my DIY CNC Router
AtienzaLouie
141 views
While I'm waiting for a replacement xylotex board, I had to get my machine up-and-running. So I installed the G540 box, sold and assembled by DeepGroove1.
The enclosure...
-
DIY CNC Milling Guitar Neck, Part 3: The Result
AtienzaLouie
199 views
Here is the end result. Overall I'm happy with the result, though I might try a combination of planar finishing for the neck back, and steep wall finishing for the volute ...
-
DIY CNC Milling Guitar Neck, Part 2: Finishing
AtienzaLouie
193 views
In this segment, I'm using OneCNC XR4's 3D offset strategy as a finish pass. Looking back, I probably could have done a planar finish. I'd have to try it to see which is ...
-
DIY CNC Milling Guitar Neck, Part 1: Roughing
AtienzaLouie
310 views
In this video, I am roughing out the contours of the back of a guitar neck blank.Using OneCNC XR4's open pocket Z level roughing toolpath. I might reprogram this to start...
-
DIY CNC Router, cutting BASS GUITAR BODY, part 2: CONTOUR ROUGHING
AtienzaLouie
220 views
Roughing out the contours on the back. Please see the other vids in this series for details...
-
DIY CNC Router, cutting BASS GUITAR BODY, part 4: POCKETING
AtienzaLouie
111 views
I thought it would be fun to try high speed pocketing on wood! I could have used a 1/2" bit to rough, but it would have required a tool change for the corners. Also, I fe...
-
DIY CNC Router, cutting BASS GUITAR BODY, part 3: CONTOUR FINISHING
AtienzaLouie
157 views
Here I'm using OneCNC XR4 3D offset finishing strategy to clean up the stairstepping from the roughing operation.
Using a 1/4" ball endmill. I believe I was a little co...
-
DIY CNC Router, cutting BASS GUITAR BODY, part 1: PROFILING
AtienzaLouie
265 views
In this video, I am doing the profile cuts for a bass body, out of a 1-piece billet of northern ash.
Using a 1/2" single flute motise compression spiral bit, at about ...
-
DIY CNC Cutting US Army Logo in Aluminum Part 3: V-Carving
AtienzaLouie
911 views
Here I am doing the v-carve, with a 60 degre drill-mill. This isn't exactly the proper bit for the job, but it did well. I didn't accurately measure the flat of the tip, ...
Play all(63)