AEVector's channel
Loading...
90
subscribers
18,700
video views
Uploaded videos
1-10 of 18-
Timer and gearing installed - Chalkalis EM Replication
AEVector
345 views
Even without power being pulse drawn from the generator (open circuit) , the bogging is bad enough to stop the rotation, so I may have to increase the weight. I'll also mov...
-
Gererator Testing
AEVector
262 views
Testing of the generator I will be using for output of the Chalkalis EM device. At 1800 RPM the generator outputs 9V and 8A (72 Watts) with a 1 Ohm load. With the 12 V lamp...
-
Chalkalis EM Replication with Generator
AEVector
544 views
The generator is on the system but not directly attached yet. I still need to make my timing disk which will use the Muller-Romero timing circuit. The drive motor is a Lock...
-
Chalkalis EM Replication First Motor Test
AEVector
539 views
Here is a rough first test with a 24 Volt DC drive motor. At 14.6 V and 2.10 A (30 Watts), the motor is spinning at about 180 RPM. I'm sure I can double that speed at 24 vo...
-
Chalkalis Energy Multiplier Replication Initial Hand Spin
AEVector
455 views
This is my replication of the Chalkalis Energy Multiplier. It is 30 inches in diameter.
If the energy input is pulsed at the right time and position in its 360 degree ro...
-
Gas Separator Cell (GSC) installed on Honda Odyssey
AEVector
483 views
Here's the GSC installed in my 2005 Honda Odyssey. I'm getting about 600 mL per minute of hydrogen output at 15 amps, cold start. MMW is low at around 4 MMW because I'm tak...
-
GSC Rebuild
AEVector
144 views
I rebuilt my separation gaskets. This time I took my time, making sure there was enough glue between the gaskets and nylon fabric, clamping it properly, and letting the glu...
-
Breakdown of GSC Electrolyzer
AEVector
226 views
This is a result of my hasty build of the gas separation gaskets. I need to glue the nylon fabric more carefully.
-
GSC Hydrogen vs Oxygen vs HHO Ignition
AEVector
392 views
This is a replication of Bill Williams GSC Electrolizer. It has 2 sets of 5 neutral plates and 3 active plates (13 SS 316 plates total). There is about 21 volts between the...
-
Replication of RomeroUK-Muller Dynamo
AEVector
920 views
This is my replication of RomeroUK's/Muller Dynamo. I have all 7 generator coil pairs hooked up in parallel and attached to a 47000 uF 35V cap. Only one of the coil pairs h...
Advertisement
About AEVector's channel
more
less
Play all(18)