17paulmac

nice fly day, and the park looked good too,I dont remember the sky being that blue when i lived in Ireland,that was N ireland:) still nice flying good luck with the rest of your flying in the future .

nice one man.

nice camera work man:)

Nice lake man, I have one of these wings ,you may have seen my review of it,it does get touchy,on launch,unless you put in approximately 5 or 6mm of up elevator,i dont use any expo on it anymore ,I set it at 50% now on elevators and the same o n ailrons and it now is much easier to fly .I will b...

I have this TX Turnigy TGy9x,it looks like a good TX ,but I got a dx6i I think for me it is easier to figure out the dx6i ,anyway thanks for your input and advise on elevons thats about where i set them for the sytker and fun jet, 60% on everything,I thought being a EDF it would be different,som...

nice flying ,I got one of these wings with a 2836 2350kv turnigy motor on 2.2mah 40c lipo,if you want more speed try that set up:) but I think you would need to find a bigger flying field :( Good video thou )

I noticed you have a review on the jetiger! you get around here on you tube tsisapik:)I have just purchased this EDF ,its my first EDF since learning to fly,with out a gyro,what would you say you would set the throws at and if any EXPO would be required, in a Dx6i TX?Thanks 17paulmac.

nice video, got my cam yesterday,real good the 720p HD 11 808,for such a small thing,eh:)

can you give some measurements of the hot wire frame and lengh of wire used,the frame looks like its made from plastic pipe? maybe a plumbing pipe?I see here some comments say that if the cutting wire is to long then the heat will not be enough to cut the foam ?if one doesnt have a regulator for ...

I wont be maken a video just yet of the flying wing,as my $7 key chian camera died ,so I have ordered a better one from ebay, 264 Hd 11 $40 :) still waiting on it.iam not airbrushing the wings yet,when I get it Iam just going to mod it like the last one,thanks for your comments,and go with the b...

no glass for this wing its very strong EPO and the thing went into the ground more times than enough, but it is still ok with a little bit of glass strapen tape was going to fly it this morning but Its blowen about 30 odd knots out side ,so I will have to put it off for now,as soon as the weather...

Hi Nice flying ,I like that plane it looks like a 27c parkzone stryker after you added the stabs:) I would like to get one of these planes to add to the flite which consists 0f Stryker Sky fun and a fun jet by multiplex.is it made in the usa? or imported from china? Thanks in advance,BTW it would...

Btw Frank I just ordered the sky fun,hope you get back to me before I try and fly it:)I have watched a lot of your rc foam fighters videos ,you guys are into speed,the info is really good on the bats to use and the motors and upgrades,but iam thinking I never hear you guys say ,iam going to set t...