114059
Loading...
5.56 x-tac vs .75" thick plate steel
shooting a few rounds into a piece of 3/4" thick plate
114059
uploaded
-
6 months ago
114059
commented:
the t56 is out of an lt1 trans am. if you use a 350 with a 1 piece rear main seal and an lt1 flywheel the transmission bolts right up with the factory trans am bellhousing.
Last cruise before winter
taking the Z out one more time before the snow really falls
114059
uploaded
-
1 year ago
114059
commented:
Plenty of room to get at the rear header bolts. The dist has plenty of clearance between the firewall, but I had to take out the hood latch because my distributor is too tall. I don't like it, but the hood is held down with hood pins now.
Loud Datsun 280z small block swap
my project, getting closer to being drivable.
motor is finally set and timed. maybe a few more tweaks later on. exhaust is only run back to the di...
114059
uploaded
330hp 350 sbc in 1977 Datsun 280Z
350 sbc world products sportsman II heads, ,ild cam. msd ignition is hitting the rev limiter way too low. otherwise she runs good!
114059
uploaded
-
1 year ago
114059
liked
1982 Trans Am Dual exhaust
vortec 350, stock except intake and 600cfm carb, LT headers into dual 3" pipes with glasspacks
114059
uploaded
2006 Saab 9-3 2.8t Muffler Deletion Sound Clip
2006 Saab 9-3 Aero V6 2.8T Muffler Delete.
114059
commented:
lots of wind noise, but as far as i can tell that sounds really good.
saab 900se exhaust
'95 900se 2.0 turbo, stock down pipe with high flow cat, resonator removed, with 2.5" dynomax turbo muffler.
114059
commented:
it's actually not very loud inside the car, I have to have the windows down if I really want to hear it.
Suprise for Ya!!
A video for you guys before I have to get my wisdom tooth pulled =( ENJOY! =)
114059
commented:
WHAT THE FUCK, go talk to a wall.
saab 900se exhaust
'95 900se 2.0 turbo, stock down pipe with high flow cat, resonator removed, with 2.5" dynomax turbo muffler.
114059
uploaded
the exhaust is run all the way out the rear valence, through quad tips like a corvette. I might go back and put in a crossover "x" pipe and change the mufflers and tips this winter.