0rionsHammer's channel

Short 420fps slow motion shot (14x slowdown) of my AR-15 firing. It's got a blue lower receiver that I milled myself from an ordinary HDPE cutting...

In this video I update the status of my from scratch AR-15 lower. Highlight some issues I had with the original lower and show the new fully functi...

Here I'm test-firing a home-built semi-auto pistol that uses PPSh-43 magazines holding 32 rounds of 7.62 Tokarev. Here's how I built it:

http://w...

Here's a plastic trigger, hammer, and disconnector for the AK-47. I cast these parts myself from a two-part urethane, reinforced with fiberglass i...

CUTTING 4340 STEEL 30 ROCKWELL AT 11 CU IN. MRR

Time to make a hose clamp for my Case 580 SE Backhoe. Yeah, I could order one from the dealer, but that would suck all the fun out of owning an ol...

This video was made to demonstrate the increased effectiveness of a rifle with a 1X forward mounted optic. PLEASE NOTE: We were ONLY able to do...

This video shows me vacuum forming a head casting out of plaster. check out my website: www.maartencnc.com

Here's a 1911 pistol being shot in true slow motion. The first clip is at 210fps, then we switch to 420fps--you can actually see the 45acp bullet ...

I test fire my AR-15 rifle with a lower receiver that I milled from a blue polyethylene cutting board, as detailed here:

http://www.weaponeer.net/f...

I test fire my AR-15 rifle with a lower receiver that I milled from a blue polyethylene cutting board, as detailed here:

http://www.weaponeer.net/f...