08Maxwell1

Have you ever needed to find the center of a circle. Well, this video will teach you how to do that without any measuring at all.

"Hands" is a foundly remembered Irish television program that ran from 1977 until the early 80's and showcased some of the country's finest craftsm...

http://jrhagercards.blogspo... - (717) 721-4672 - An introduction to Amish Buggy and Carriage making in 2010 ....from Amish Jack

A barn/garage/loft studio in traditional 100% oak framing and cladding. Designed by Conservation Architecture & Planning. For more information con...

This is a accurate 1/16 scale operating model of the engine which powered the

Civil War Ironclad USS Monitor. It was invented and built by John Eri...

This is the second half. My computer is shutting me out too early. I will put up the balance tomorrow and then one on vac chucking and finishing...

The SW-20 is a great little QRP rig, however it is very sensitive to high SWR. Since there is no fail safe, if SWR is exceeded, the final power am...

MACHINE SHOP TIPS #64 Clausing Lathe Gibs Pt 2 tubalcain

MACHINE SHOP TIPS #63 Clausing Lathe Gibs Pt 1 tubalcain

The Mega-tip-over of the christmas marble run 2010 that drop 1000 marbles through some bell streets. This marble run (or marble machine) has also a...

Marble Machine (definition: A Do-Nothing or Rube Goldberg Type Machine)

This is intended to be an awkward, overly complicated mechanism for the s...

http://woodgears.ca/pantogr...

Using my 3D pantograph to cut some round bowl lids

http://www.woodthatworks.co... Spring driven kinetic sculpture by David C. Roy "For this design I wanted to use very ...

Video to encourage students to work out at the SDSU Aztec Recreation Center.

http://www.buzzfeed.com/201...

An experiment to see if my elecrtric furnace was suitable for melting brass. This was the first time I have tried a brass casting. The small size o...

Building the parts for my modular shed

http://woodgears.ca/shed/bu...

http://www.newwoodworker.co...

The full review has lots of detail and pricing information.

How To Video showing a not-so-simple modification to a scroll saw for effective dust collection. This Delta 40-530 Scroll Saw proved more difficult...

Viper's Vulcan Rest and Instructions

Forging of traditionally smelted Tamahagane, on a Nazel 3B power hammer in Oakland, California. If you have the means, I highly reccomend one.

http://www.thewoodwhisperer...

The traditional method for flattening a workbench is ...

How to make dowelling in the home workshop. Steve Maskery from http://www.workshopessentia... show you how to make a simple jig for the producti...

One hour north of Dublin in the Boyne River valley, evocative 5000-year-old (older than the pyramids!) burial mounds sprout from the lush Irish cou...

This 1920's era model tool shop was built over a 3 year span (2007-2010) in about 600 man hours. It was built from scratch and is an original desi...

Part 3 of a series about importing a 1909 Maxwell into Australia. The

trip home and getting it to go

Tubalcain shows how to cut off stock on the Atlas & Clausing lathes. Part 1 of 4.

To down load this issue of PM, do a google search for POPULAR ME...

Old Southbend instructional movie

Tubalcain shows off an old Elgin lathe.