haha. its funny to see all of these comments on the job. cosmetics are only that. you cannot judge the performance of a system by looking. go get you meter gauges and testers to see how they did.you can't even see what size house or equiptmen. it could be over or undersized. and to the company york is a joke. bristol comps are not in the same league as copeland scrols. not to mention ive put it in and the only thing ive found cheaper quality is fedders. hava good day every1.
I'm sorry you had a York installed in your home. Have you changed your leaky drain pan in your furnace yet? How about your a coil. You might want to have that changed if you haven't already the warranty is ticking. That lx outdoor unit better have been charged in the heat of the summer or it is probably over charged. Next time you change your heating and ac system, do more research.
@mufichman thesee install guy do this shit 5 times a week dont u think they know wtf their doing, and u dont have to do charges in the summer only i did em in the winter all the time the fall everything u can charge by ur air temps super heat and subcooling is the best way to charge doesnt matter the weather outside
Like to see the final job the 2 vent pipes, and the last hole they made. It looked like a clean job, somethings I would have done differant but over all from what I seen it was clean, York is ok, I use it from time to time.
Nice job, but a few concerns. 1- the holes that were drilled in the floor joists are not to code. The hole can be no larger than the width of the joist and min width height up the joist.Therefore a 2 1/2" hole is 1" oversized. Also if the high voltage wire can be routed through the joists instead of under, it would be alot better. Some areas you cannot run wire that way.
York shit
Hv1245 5 months ago
haha. its funny to see all of these comments on the job. cosmetics are only that. you cannot judge the performance of a system by looking. go get you meter gauges and testers to see how they did.you can't even see what size house or equiptmen. it could be over or undersized. and to the company york is a joke. bristol comps are not in the same league as copeland scrols. not to mention ive put it in and the only thing ive found cheaper quality is fedders. hava good day every1.
2011bhop 6 months ago
nice job
MrMadden73 1 year ago
no, Afton, MO.
bflynn221 1 year ago
I'm sorry you had a York installed in your home. Have you changed your leaky drain pan in your furnace yet? How about your a coil. You might want to have that changed if you haven't already the warranty is ticking. That lx outdoor unit better have been charged in the heat of the summer or it is probably over charged. Next time you change your heating and ac system, do more research.
mufichman 1 year ago
@mufichman thesee install guy do this shit 5 times a week dont u think they know wtf their doing, and u dont have to do charges in the summer only i did em in the winter all the time the fall everything u can charge by ur air temps super heat and subcooling is the best way to charge doesnt matter the weather outside
Wilkinsj 1 year ago
Like to see the final job the 2 vent pipes, and the last hole they made. It looked like a clean job, somethings I would have done differant but over all from what I seen it was clean, York is ok, I use it from time to time.
Nutintoitbut2doit 1 year ago
misty mountain hop! nothin like a little page and plant to keep you busy on the job
satriani32 1 year ago
Comment removed
xctome 1 year ago
Nice job, but a few concerns. 1- the holes that were drilled in the floor joists are not to code. The hole can be no larger than the width of the joist and min width height up the joist.Therefore a 2 1/2" hole is 1" oversized. Also if the high voltage wire can be routed through the joists instead of under, it would be alot better. Some areas you cannot run wire that way.
Rinconmaniac 2 years ago
Is there seal tight conduit on the wire between the disconect and the outdoor unit, or is that just romex wire?
tstatech 2 years ago
York. I'll pass on the compliments to Anton's HVAC in Afton, MO.
bflynn221 2 years ago
@bflynn221 u mean alton, mo?
Wilkinsj 1 year ago
hey what brand was your old unit?
acthetech 2 years ago
i own my own hvac company and i can really appreciate a good looking job. this looks great, kudos!
atreyu252525 3 years ago
Someone is not wearing his safety goggles when coring.... tisk tisk.. looks like a good job though.
Epicx1984 3 years ago