2 min. colloidal batterie device hack

[daniliver]

Hello , I bought on ebay a dc-dc regulator max input40v max output 35v.

Will i need also to add a resistor in the lines? between the silver and the dc regulator i mean. Its a cheap 5€ regulator btw.

[pulsarLi]

@daniliver

Hi, if you have much Amps in the imput, I suppose you'll have it also in the output. you can measure the amps, when it's more than 30mAmp you better use a resistor

[daniliver]

@daniliver Hello , I found very good site with plenty of info , it is called silverlist . It´s necessary to put 30v ,0.6milliamps, 50kohm resistor/potentiometer . Water spin using a milk cream maker and is not necessary two rods of silver but one , the anode + which is the one that puts particles into the water ,the other can be inox steel.

[jlamm001]

if you use distilled water and our pure 99,99% silver rods, you'll not have any problems with ingesting. Stopp production before it becames colored.

look the guide on "how to make high quality colloidal silver. The 6 main criterias" on pulsar.li

[darksmiley]

there are a few problems with this for ingesting. But it will work for topical silver solutions

[Jesus4YouCH]

for 3x9volg batteries I use 3.3Kohm resistor.

this makes 27 / 3.3 = 8 mAmp

for 1x 9 Volt you can take a 1,1 Kohm 9 /1,1 = 8,1 mAmp

anything betwenn 2 and 15 mAmps is not bad.

mAmp = Volt / Kohm

[MrSlickslack]

HI WHAT OHM IS THE RESISTOR. GREAT IDEA THANKS

[Jesus4YouCH]

@MrSlickslack

answer below

[naanaa1111]

What is the holder? Where do you get one?

[jlamm001]

@naanaa1111

the holder is the orange part, where you screw the electrodes. you can get them in many shops. You can also take some crocodile clips instead of this srew-holder.

[hotdogfriend]

wieviel Ohm benötigt der Widerstand?

Which resitor is needed?

Danke für die Info - Thanks

[jlamm001]

Hallo, bei 15-30 Volt ist 3.3 KOhm gut, das gibt dann etwa 2-10 mAmp. Es geht auch ohne Widerstand, aber bei paar hundert mAmp ist der Vorgang grob, dafür schneller.