Bazzaz Performance ZFi software for mapping and tuning

[03dalmau]

why does mt TPS goes crazy jumping up and down? Also when I do all these steps and hit start it will not start mapping. I have the bike lifted from the rear with a swingarm lift and running through gears. i check the track operations on it but doesn't start to map. I tried and hit the start button and took it for a ride to map it this way but when i get back I see no numbers. I have the z-fi and the z-afm installed. need some help on this. I have a stock motor with a TRE and turbo.

[islandboi1988]

@a6km Power Commander only allows u to tune 4 injectors tho, not the 8 that Bazzaz does. Both are good in their own ways..

[a6km]

Power commander enables to make adjustments every 250 rpm Bazzaz only 500 rpm so Power commander wins. Makes me wonder why Bazzaz wont do 250 rpm adjustments as well/

[maddasstoner]

Ok so what if you don't have a dyno, can I just set it up and run it around then put it back on laptop will it make the same temp map with recommended changes that can be applied in other words does it data log for future changes?

[jfergmon]

Are you kidding?? Ya 14.7 is the optimum but I'll burn ur motor up with that setting. 12.8-13.2 for best motor longevity and preformance. Check out Motomummy for a good write up on the install/using the bazzaz software.

[rodo209]

For best results set air/fule at 14.7:1

[naminseniazei]

W O W!!

Thanks a lot!

[ZacGot1]

awesome post real simple