P5142473

[zaagmans1]

What happens if you add magnets in the biggest gap?

[sparkyrocky12131963]

this is mylow brothers (my friend you are very close to full rotation keep up the good work. this looks like the one my brother biuld a few years ago. you are very very close to replication this is better then bedini group that tried.

[oglundasotarn]

Tony! Hello Thankyou. I´ve already rebuilt it, obviusly it dident work butt i dident filmd that. my new konfiguration however shows much better thrust. I can putt weight on my disk and it still pushes . going yo post this but today my wifes choir has an consert which will take most of the day. This non cymetry seems to be the trick. Pelle. (thats my name)

[Asymmatrix]

Finish the disk. Or should i say Finnish it.

[wjcroft]

Great job, a few more magnets around the circumference should do it. I think also your bearing friction is somewhat on the high side compared to some of the other disks we've seen. Outstanding!

[shubus]

It looks like you have very uniform gaps between your magnets---you might want to make that less uniform as Mylow has stated. but your setup looks good and you're almost there. So great work & KEEP AT IT.

[carbonccc]

Keep going. Looks good.

[flekoun13]

Do it! You can make it! Do it! Complete third set of magnets!

[slinky460]

Hang in there! It is a different design, but may be thats what is needed. Actually, I think there may be many different ways to do this. Mylows motor was just one of them.

Nice work, but camera stand please for better viewing out here in U tube land. Thanks!

[andreboogie]

Almost there! Looking forward to see you jumping, shouting and screaming!

[MAGNETGRUNT]

You are there man!!! Keep with it! Great work!!

[Firewater3]

Complete the full circle! It looks like your nearly there with more magnets on the third batch, if it jumps the first gate after one revolution it should gain momentum, fiddle with the magnet arrangment if it dosen't go through all three gates but its looking very promising

[aphost]

Härligt att se! Har du fått runt den helt?

Öglunda, i Skaraborg? Jag befinner mig i Tidaholm =) Funderar på att beställa magneter från Storbrittanien, det finns flera ställen där (länkar finns på PESWiki). Om du är intresserad kanske vi kunde beställa tillsammans.

Hade också tänkt att använda en fläkt som rotor, men kom på att istället använda mig utav en skateboardtruck istället och fästa plattan i däcket... Det går till att börja med i alla fall.

Lycka till!

Jimmy

[oglundasotarn]

dä ä rätt å recktitt, tänka säj att en skecker fiellmer över hela väla å så hammnar dum i labbås... lita värl ve lever i!

[Firewater3]

Looks like its going to work mate! it has successfully jumped two gates! A few more magnets on your third batch & you may be the first with a working replication great work!

[X00000013]

greetings from me!!

[Pirate88179]

Nice work!

Bill