it shows on the vid serial and crossover but the above vid is done with just an ethernet cable, plug the ethernet in your comp and back of the dbox ethernet port, then serarch your image select the port, dont select null if not using it, get to the point on the vid 0:30secs then plug the box in at the mains keep doing that until comp picks it up, when it does it will say loading at point 0:50 on the vid
Hello
your video is great !
may i know what is the meaning of flashing a dbox and its purpose?
Thanks
adyzal 1 year ago
THE CHANNELS HAVE GONE OFF ON THEM MESSAGE ME BACK OR REPLY ON THIS COMMENT
iHDiLewiziHDi 1 year ago
@iHDiLewiziHDi yes areas are being switched over to nagra 3 nothing can be done was good while it lasted
mikeyt1981 1 year ago
could u plse tell me were i can get commando 6 image from were i could downlaod it 4rm
khakaan123 2 years ago
This has been flagged as spam show
pm me your email and i'll send you a few images, or sites where you can get images from.
pathaanx 2 years ago
thank you !!!
PROFmatheo 3 years ago
hey - good guide - what software did u use for the video editing?
theManofScienceUK 3 years ago
used camtasia snagit and adobe cs3 combo of all 3
mikeyt1981 3 years ago
Absolutely execellent have no troubles after this
djgryder 3 years ago
it shows on the vid serial and crossover but the above vid is done with just an ethernet cable, plug the ethernet in your comp and back of the dbox ethernet port, then serarch your image select the port, dont select null if not using it, get to the point on the vid 0:30secs then plug the box in at the mains keep doing that until comp picks it up, when it does it will say loading at point 0:50 on the vid
mikeyt1981 3 years ago
how do you mean connect propperly, in what sense? via ifa or ftp?
mikeyt1981 3 years ago
hope this has helped you all in some sort of way
mikeyt1981 3 years ago