Where is your transducer located? In the water on on the outside of the glass. You need to adjust the frequency of the transducer to either vibrate the plates so that it as close as possible to breaking the water partial. I figuring out that it will take less current one you get to this point and it will reduce the heat. I'm thinking about using a transducer on each plate in a dry cell ?? New to all this, yet I find it fascinating:)
I tried this with an immersed pond fogger a couple of years back. Found the same results as you. Was thinking to immerse a crystal earpiece in the water & use as an inefficient microphone to measure fogger frequency on my scope. With a view to tuning the cell tubes to the ultrasonic frequency. Efficiency didn't improve initially, so I gave it away, never thought of testing the gas for power the way you did ...good idea!
quite large.. current through the "capacitor" is based on the conductivity of the dielectric material. i wnder what factor yields greater generation, high voltage or high current?
stanley meyer's take on electrolysis is logical for me. voltage difference arranges the h20 molecules then further increase in potential difference cracks the bond between the hydrogen and oxygen.
The plates are so close together that collecting the bubbles and separating them would be very difficult. One might try that if the plates were further apart.
Have you noticed any change in production rate while the ultrasonic generator is turned on? Any change in amp draw? Looking for effiency improvements here..
The amperage stays the same no increase or decrease. The volume output does seem to change a little bit. The volume is decreased a small amount maybe 10%. But what I have noticed is the gas is much more volatile. The bang of 1 liter is much greater. Maybe twice. I need to measure the explosive power. Mozon1967 measures his gas mixture power. This is what I need to do.
I was just given a camera with video capability on my birthday Oct 18th. This was my first post to you-tube I had no idea I would rouse so many nasty comments. So If you don't have anything good to say don't bother
because you will be blasted out. I thought this a worthy discovery and was willing to share with a nice request eliminating do nothing looky loosers.
Philo T. Farnsworth Said When asked in a KSL-TV television documentary years later about Zworykin's contributions, Farnsworth replied: "I have no doubt that God could inspire two scientists at the same time and in different places with similar ideas."I have been obsessed with this HHO and other Zero Point inventions for over a year now.
The Ultra-Sonic device was purchased over the internet on 9/11/2007.
Even the wall plate construction was an Idea I came up with after getting an outrageous quote from a sheet metal shop for some designed plates. You can believe this or you won't I don't care.
To those that think this was copied from sirHoax. Prior to viewing the responses, I had no knowledge of his work. I have been following a dozen others but not sirHOAX. This work was done in late September.
Where is your transducer located? In the water on on the outside of the glass. You need to adjust the frequency of the transducer to either vibrate the plates so that it as close as possible to breaking the water partial. I figuring out that it will take less current one you get to this point and it will reduce the heat. I'm thinking about using a transducer on each plate in a dry cell ?? New to all this, yet I find it fascinating:)
craigglewis 8 months ago
I tried this with an immersed pond fogger a couple of years back. Found the same results as you. Was thinking to immerse a crystal earpiece in the water & use as an inefficient microphone to measure fogger frequency on my scope. With a view to tuning the cell tubes to the ultrasonic frequency. Efficiency didn't improve initially, so I gave it away, never thought of testing the gas for power the way you did ...good idea!
smokyatgroups 1 year ago
is the device that nucleates the hydrogen simply ventelation? how does it work?
aradioactivedonut 1 year ago
amperage and voltage input?
teji101 3 years ago
The Voltage was 12V and the Current was 18Amps from a car battery.
AllgoodAutomation 3 years ago
quite large.. current through the "capacitor" is based on the conductivity of the dielectric material. i wnder what factor yields greater generation, high voltage or high current?
teji101 3 years ago
Faraday states its all due to current.
BUT Stanley Meyer Says it's all due to voltage potential with one caveat you must collect the freed electrons which means current flow. HMMM
Sounds Like Faraday was on to something.
AllgoodAutomation 3 years ago
stanley meyer's take on electrolysis is logical for me. voltage difference arranges the h20 molecules then further increase in potential difference cracks the bond between the hydrogen and oxygen.
i think i have to study those theories again..^_^
teji101 3 years ago
Question, have you tried collecting the Oxygen off the + lead, and Hydrogen from the -?
smartputty 4 years ago
The plates are so close together that collecting the bubbles and separating them would be very difficult. One might try that if the plates were further apart.
AllgoodAutomation 4 years ago
Have you noticed any change in production rate while the ultrasonic generator is turned on? Any change in amp draw? Looking for effiency improvements here..
UserName732492 4 years ago
The amperage stays the same no increase or decrease. The volume output does seem to change a little bit. The volume is decreased a small amount maybe 10%. But what I have noticed is the gas is much more volatile. The bang of 1 liter is much greater. Maybe twice. I need to measure the explosive power. Mozon1967 measures his gas mixture power. This is what I need to do.
AllgoodAutomation 4 years ago
I was just given a camera with video capability on my birthday Oct 18th. This was my first post to you-tube I had no idea I would rouse so many nasty comments. So If you don't have anything good to say don't bother
because you will be blasted out. I thought this a worthy discovery and was willing to share with a nice request eliminating do nothing looky loosers.
AllgoodAutomation 4 years ago
I know it to be true.
I believe that inspiration is a gift from god.
Philo T. Farnsworth Said When asked in a KSL-TV television documentary years later about Zworykin's contributions, Farnsworth replied: "I have no doubt that God could inspire two scientists at the same time and in different places with similar ideas."I have been obsessed with this HHO and other Zero Point inventions for over a year now.
AllgoodAutomation 4 years ago
The Ultra-Sonic device was purchased over the internet on 9/11/2007.
Even the wall plate construction was an Idea I came up with after getting an outrageous quote from a sheet metal shop for some designed plates. You can believe this or you won't I don't care.
AllgoodAutomation 4 years ago
To those that think this was copied from sirHoax. Prior to viewing the responses, I had no knowledge of his work. I have been following a dozen others but not sirHOAX. This work was done in late September.
AllgoodAutomation 4 years ago
thanks, what exactly is "THE DEVICE"
Cheers Bill
madbillt66 4 years ago
ultrasonic? Sir Hoax has a vid on his experiment
with a pond fogger, vid #41
rc9340 4 years ago
Yea its a ultra sonic fish pond fogger. You can find them on eBay. Its not something he made, he bought it and dropped it in the HHO-Cell.
sirHOAX 4 years ago
Hi My name is Thomas I have been it seems working on the same things you have. Would you like to collaborate? Please RSVP
AllgoodAutomation 4 years ago
vacuum
eclipse0982 4 years ago