what is the difference between BBks and yours just asking because BBks are $600 and yours are $1340 I have a company called Brenspeed installing them i have a saleen supercharger on my 2000 GT just want to know.
what is the difference between BBks and yours just asking because BBks are $600 and yours are $1340 I have a company called Brenspeed installing them i have a saleen supercharger on my 2000 GT just want to know.
we dont have anything off the shelf for a mountaineer, we would need it in our shop for about 7-10 days to custom fabricate headers, for more information about that, give us a call at 866-586-565 and speak with one of our sales reps and we can get you set up!
I love how they casually refer to the removal of stock manifold and install of headers. The omit to mention you have to jack up the motor, remove motor mounts, starter, steering shaft.... count on a long day
Hey there,quick question.. If I used jacks to lift the car in my garage, would it be a very difficult install? Also, I heard something about needing o2 sensor extensions or something? Does the motor need to be lifted also?
its possible to do the install yourself, alot of people do it with not problem, its just difficult because the LT headers are a pain to move intoplace but with some good jackstands and such you should be able to do it, and it be a cool thing to do. as fars as the extensions, kooks supplys your with them
The guys had a programmer for that car and downloaded a few adjusted air/fuel numbers into the programmer then downloaded the changes into the computer system into the car so it will have the correct ratio of air/fuel. if they didnt do that the car wouldnt run as well and it would not have gained the power it gained. with that supercharger you dont even need thos damn headers just switch the pulley and adjust the air/fuel, the block can only hold 450-500 or so anyways if the tune is good
I got my headers and installed myself. I enjoyed it. One disappointment. In the middle of the install I realized that the tubes where full of metal grind. I wash them with water the best I could. When we pay 1300 I would expect that you atleast give us a product without garbage in it!!
did u do it on a lift, my friend has a 02 mustang 4.6V8, and he wants to install the pace setter headers and Xpipe, but since i dont have a lift its a royal pain, since the i read that the engine has to be jacked up to remove 2 of the engine mounts.
No I did it on Jacks. it took abt 11 hours, by myself and occasional hand by the wife.... You do need to remove the mounts, and jack up the engine about an inch. You also need to remove the oil deep stick, starter, and steering column. The fitment is excellent. No issues whatsoever.
@Kookstv Informative video. Just wish we could have heard the distinctive "low rumble" you spoke of instead of music and a guy talking talking through the entire video. I'm sorry but music is for "music videos", not car videos.
I have a roushcharger on my 06 gt mustang if I put these headers on how will I retune the pcm for the air/fuel? or will I have to have a shop do it with a dyno?
i want to install kooks headers and kooks x pipe with cats and with corsa axle back exhaust. will i be able to pass emissions test at a inspection station?
Hey, after you remove the stock manifold and put on the new headers, you have to put the cover back on too? Or is it optional? Becaue it will look better if not.
Nice! I wish I had a lift to work on my car!
fullrearview 3 months ago
This has been flagged as spam show
what is the difference between BBks and yours just asking because BBks are $600 and yours are $1340 I have a company called Brenspeed installing them i have a saleen supercharger on my 2000 GT just want to know.
Thanks
MustangGT460 10 months ago
This has been flagged as spam show
what is the difference between BBks and yours just asking because BBks are $600 and yours are $1340 I have a company called Brenspeed installing them i have a saleen supercharger on my 2000 GT just want to know.
Thanks
MustangGT460 10 months ago
Comment removed
MustangGT460 10 months ago
we dont have anything off the shelf for a mountaineer, we would need it in our shop for about 7-10 days to custom fabricate headers, for more information about that, give us a call at 866-586-565 and speak with one of our sales reps and we can get you set up!
Kookstv 1 year ago
Do you guys have headers and exhaust system for a '06 Mercury Mountaineer? I own one that also has the mustang 4.6 3v V8.
datkoolbrutha 1 year ago
touch that with your finger on dyno and your finger will be gone in no time.
hamstermadness549 1 year ago
damn, that map was nice...look at the afr.
oOSTEMOo 1 year ago
how much do shory headers cost for the v6. cus im a student with a minimum wage job and i have an 07 mustang. but money is somewhat an issue
wonderbreadkw 1 year ago
how much HP can I expect with JBA shorties with a supercharger,with high flow cats??
GMurphSC06GT 1 year ago
I love how they casually refer to the removal of stock manifold and install of headers. The omit to mention you have to jack up the motor, remove motor mounts, starter, steering shaft.... count on a long day
marcuskeeler 1 year ago
they should have done this on a base gt
wellshii 1 year ago
half a day for the installation, are you serious???
rayosha 2 years ago
haha mine staid 2 days in the shop lol
2003DOHC 2 years ago
that xpipe is junk get a dr gas!
fuzzey169 2 years ago
Sure...
chompychomps 2 years ago
Hey there,quick question.. If I used jacks to lift the car in my garage, would it be a very difficult install? Also, I heard something about needing o2 sensor extensions or something? Does the motor need to be lifted also?
mustangt07red 2 years ago
its possible to do the install yourself, alot of people do it with not problem, its just difficult because the LT headers are a pain to move intoplace but with some good jackstands and such you should be able to do it, and it be a cool thing to do. as fars as the extensions, kooks supplys your with them
biffnacid 2 years ago
That's a pretty good gain for just headers, Xpipe, and air/fuel adjustment.
TheApacheHunter 2 years ago
i would like to see what the kooks did without a tune first, to really see how $1000 dollars is spent.
gflugrad 2 years ago
im a little ignorant but still want to know lol what does the tune do
sermusgt97 2 years ago
The guys had a programmer for that car and downloaded a few adjusted air/fuel numbers into the programmer then downloaded the changes into the computer system into the car so it will have the correct ratio of air/fuel. if they didnt do that the car wouldnt run as well and it would not have gained the power it gained. with that supercharger you dont even need thos damn headers just switch the pulley and adjust the air/fuel, the block can only hold 450-500 or so anyways if the tune is good
brittonmaxwell 1 year ago
I got my headers and installed myself. I enjoyed it. One disappointment. In the middle of the install I realized that the tubes where full of metal grind. I wash them with water the best I could. When we pay 1300 I would expect that you atleast give us a product without garbage in it!!
vm7007 2 years ago
did u do it on a lift, my friend has a 02 mustang 4.6V8, and he wants to install the pace setter headers and Xpipe, but since i dont have a lift its a royal pain, since the i read that the engine has to be jacked up to remove 2 of the engine mounts.
any help?
emsotakon 2 years ago
No I did it on Jacks. it took abt 11 hours, by myself and occasional hand by the wife.... You do need to remove the mounts, and jack up the engine about an inch. You also need to remove the oil deep stick, starter, and steering column. The fitment is excellent. No issues whatsoever.
vm7007 2 years ago
If your spending the money on Kooks, have the tune done.
cutator 2 years ago
It is not required, but to maximize the performance output I would reccomend one.
Kookstv 2 years ago
@Kookstv Informative video. Just wish we could have heard the distinctive "low rumble" you spoke of instead of music and a guy talking talking through the entire video. I'm sorry but music is for "music videos", not car videos.
rmorgan284 1 year ago
Do I have to get it dyno tuned?
Razrstang 2 years ago
i have kooks on my 2valve and thier great... but without the tune the results would not have as good
mustang4life04 3 years ago
i just got my car back with these headers, vt stage 2 cams, and an h-pipe and it is the best sounding mustang where i live
2004mustangkid 3 years ago
Glad to hear it!
Kookstv 3 years ago
I have a roushcharger on my 06 gt mustang if I put these headers on how will I retune the pcm for the air/fuel? or will I have to have a shop do it with a dyno?
charliedip 3 years ago
I would reccomend getting it re dyno tuned. That would be the best option for you to go with.
Thanks,
Kookstv 3 years ago
i want to install kooks headers and kooks x pipe with cats and with corsa axle back exhaust. will i be able to pass emissions test at a inspection station?
StngRayCorv 3 years ago
You should be able to install the headers and pass inspection. The only way it will not pass is if you are in California.
Kookstv 3 years ago
How about without the S/C??? Come on...
03flstfi 3 years ago
Hey, after you remove the stock manifold and put on the new headers, you have to put the cover back on too? Or is it optional? Becaue it will look better if not.
Please reply.
mat663 4 years ago