Zbrush 4.0r2 Creating a Mechanical Insert Brush

[10011001100010001010]

07:09 -> 07:11 u used hot key ?

i can't do it.

[boooooooooozer]

Thanks mate, Love your render demo as well

[LEGIT134]

Inspiring...

[eelexa]

Thanks for this, I haven't been able to get R2 yet but when I do.. 

[InTheCity3D]

Typically this would work for me, especially with other insert brushes.

However with your collection, I'm left with the insert itself and not the cut.

It's as though the sphere cuts away from the inserts.

What is the correct key combination for a cut? Should be Alt right? Doesn't work for me, for whatever reason.

[JVIikel]

@InTheCity3D Hey Dude,

The reason for this is with subtractive insert brushes, the original mesh must be a higher resolution than the stamp itself. So if you're ending up with one half of the brush instead of an insert cut, increase the resolution of your dynamesh. Hope that helps!

[skyhawk77]

Cheers dude, this the kinda thing I'll be using for futuristic mechanical stuff, just got R2 yesterday :)

[dangraphic]

Awesome tutorial man... thanks!

[i7zan]

Holy sh*t it worked. Thanks a million, man...I was doing it wrong with my laptop with 3Gb Ram :))

[i7zan]

So if after remeshing it keeps the wrong side, like it did for you the first time you tried the brush, you simply up the resolution?

[Imhotep397]

Have you tried retopo with any of these Dynamesh meshes?

[Imhotep397]

Damn that mesh is dense!

[Basurci]

So it will make hard surface sculpting much easier?

[i7zan]

Oh, a friend just told me this is in R2...sorry for spam :D

[i7zan]

Been tinkering with ZBrush for about a month and never knew DynaMesh existed...thanks for the tutorial :)

[SupaPoopaScoopa]

@i7zan Only the new release has dynamesh that came out on 20th-21st