go to kentucky dept of fish and wildlife website. click on the television link, and that brings up a link to build a flat bottom boat. Has a video of them building one and the plans
use (3) 1x12x10 ft. cyress,mahogany or oak boards for sides and ends. Either buy or make tongue and groove boards for bottom, caulk the groove of each board. Pine 1x8 for benches. Treat with Cuprinol and paint with marine paint. Figure the width of both ends no less than 33 inches wider in the middle. Use
3M 4200 for adhesive (walmart marine). Git Er Done!
I'm from MO and we got lots of rivers, I got boats but I think my g/f and my dog would like this boat. " moy dog likes to jump in and out of the boat." I think i'm going to make one.
what kind of baitcaster is that??
JJB1021 1 month ago
would a flat bottom boat be ok to use on a lake?
TheTeamCurve 2 months ago
how much did it cost to make per boat
lildrumerboi95 8 months ago
does it matter if the gunwale is just a rectangle?
polerigger 10 months ago
i love your videos their the best
flypaintball428 11 months ago
this i call if you can't cautch good fish it's good to be outside od fresh air :)
Dean9Kovach6 1 year ago
I tell you what, They get the job done and affordable too :) But what say you all invite us to go fishing too :)
Thanks for sharing,
Tewrobert 1 year ago 4
plans, and how to video are on the kentucky fish and wildlife web page, under tab for television, and how to build a flat bottom boat.
Smitty2579 2 years ago
@Smitty2579 I can not find the plans. can you help me? I will build one of these this weekend.
rayvila1@aol.com
Thanks, Ray
LandonRocksAtGH 6 months ago
go to kentucky dept of fish and wildlife website. click on the television link, and that brings up a link to build a flat bottom boat. Has a video of them building one and the plans
Smitty2579 2 years ago 2
Has anyone found the plans to build one of this? I am planning to build a 10' one but don't know where to start.
militol 2 years ago
use (3) 1x12x10 ft. cyress,mahogany or oak boards for sides and ends. Either buy or make tongue and groove boards for bottom, caulk the groove of each board. Pine 1x8 for benches. Treat with Cuprinol and paint with marine paint. Figure the width of both ends no less than 33 inches wider in the middle. Use
3M 4200 for adhesive (walmart marine). Git Er Done!
biggyrat57 2 years ago
great video. Now I got to build one of these.
madman4049 2 years ago
Do these need to be a certain size to float or will a smaller one work also? Does anyone know if there is a minimum displacement for efficacy?
TheRoxboy 2 years ago
Well that is very neat :)
billytaylorfamily 2 years ago
I'd like to build one of these. If anybody has the plans let me know.
KentuckyHoundsman 2 years ago
I'm from MO and we got lots of rivers, I got boats but I think my g/f and my dog would like this boat. " moy dog likes to jump in and out of the boat." I think i'm going to make one.
9showoffsin1 2 years ago
Where can i get the plans for a boat like this?
LBSBandit 2 years ago
man iwhs i could build one..
baarr0w 2 years ago
Great video. Is the pattern they used to build these available?
pdrow1 2 years ago