It actually has the outer part of the wheel connected to a reduction gear inside of the main rim assembly. When the wheel spins forward it engages the system and starts the spinner part moving, then when you are at speed or decelerating, the system disengages and lets the wheel spin freely
Offset such as off of a set axis or as in off of an axis and also at a specific angle? For a set axis just select the work plane button, then select your desired work axis in the bottom left part browser bar and drag the plane to the desired offset. For an angled axis you would have to set up two perpendicular planes and drag a new plane which intersects the two planes, then just adjust the end plane offsets, then check your angles relative to the part.
I've always wondered, does this have two axles>
mattthebacklash360 2 years ago
It actually has the outer part of the wheel connected to a reduction gear inside of the main rim assembly. When the wheel spins forward it engages the system and starts the spinner part moving, then when you are at speed or decelerating, the system disengages and lets the wheel spin freely
MclarenF1CMS 2 years ago
Nice. I worked with Pro Desktop and am wondering how to make an off set plane in Inventor 2009.
Thanks
mtd076 3 years ago
Offset such as off of a set axis or as in off of an axis and also at a specific angle? For a set axis just select the work plane button, then select your desired work axis in the bottom left part browser bar and drag the plane to the desired offset. For an angled axis you would have to set up two perpendicular planes and drag a new plane which intersects the two planes, then just adjust the end plane offsets, then check your angles relative to the part.
Hope this helps. =)
MclarenF1CMS 3 years ago
Nice job :D
titansteam 4 years ago
thanks, it only took about an hour and a half to make and render it.
MclarenF1CMS 4 years ago
hey, i need help do you know how to make a tire with treads on the. im doing a wheelchair. thanks
MGiambone 3 years ago