its hydraulic not hydrolic...
TheCbrrrman 5 months ago
how did you build the pvc pipe to fit the fork seal and how would i make my own for a 1984 nighthawk s 700 please email back jrhynd4174@gmail.com
jrhynd41 10 months ago
@jrhynd41 hi just made sure that the pipe was a bit bigger than the fork and then made six cuts at the bottom. I pulled it tight and to size with a cable tie. Its shown in the 1st video.
mbelik07 7 months ago
@mbelik07 my bad its in this video at 1:55 and I just cut it with a hack saw
Don't you have to bleed it and can you pop the seal by pulling it apart
mush133 11 months ago
@mush133 no, I didnt and it didnt pop by pulling apart so thats why I had to do it this way.
Yep this could work especially if you have a valve on top like I do
mbelik07 1 year ago
what about using compressed air , and jack if neccessary ?
sokotaaa 1 year ago
its hydraulic not hydrolic...
TheCbrrrman 5 months ago
how did you build the pvc pipe to fit the fork seal and how would i make my own for a 1984 nighthawk s 700 please email back jrhynd4174@gmail.com
jrhynd41 10 months ago
@jrhynd41 hi just made sure that the pipe was a bit bigger than the fork and then made six cuts at the bottom. I pulled it tight and to size with a cable tie. Its shown in the 1st video.
mbelik07 7 months ago
@mbelik07 my bad its in this video at 1:55 and I just cut it with a hack saw
mbelik07 7 months ago
Don't you have to bleed it and can you pop the seal by pulling it apart
mush133 11 months ago
@mush133 no, I didnt and it didnt pop by pulling apart so thats why I had to do it this way.
mbelik07 7 months ago
Yep this could work especially if you have a valve on top like I do
mbelik07 1 year ago
what about using compressed air , and jack if neccessary ?
sokotaaa 1 year ago