This is all still measured incorrectly. Overunity is not possible. Your fabricating skills are very good, I wish you and other talented people like you would stop this waste of time and put it toward improving efficiency and learning the proper ways to measure your ideas. Your DC amp clamp is not correct because this is not true DC. All your measurement methods are incorrect. This is a shame, because you have some great ideas, but you are looking into the sun instead of harnessing it.
I have moved on and am now concentrating on a WORKING SMOT like motor that runs continuously.
Dont need any testing to at all as the model is very powerful and not only will it turn continuously it can power other devices. A quantum leap from what i have been doing. Hope to post all when I dress up my model for presentation. It can run untill both magnets loose their magnetic power or untill the earths gravity stops functioning. Yes its not perpetual motion.
Is the spinning magnet rotating while spinning - if not, what i`m thinking is : if you build a small coil with a spinning magnet inside as a unit, then place the unit onto the big coil, so that the big coil do the spinning work, one can capture xtra energy from the little coil as well as the big coil ?
@bennjanse I recently found an even better way to produce more light output with almost perfect resonance than the test tube magnet. Found smaller magnets work best to a certain point then they dont work at all.
A 7 mm diameter diametric ring magnet -20 mm in lenght works best so far - suspended on a 25 pound nylon fishing line over the coils center hole. Its fantastic!
Hi Tom, I would like to talk to you about this. would you please e-mail me at MJEdens@yahoo.com. Thanks mje.
4323michael 7 months ago
Send me your E mail to 65t@comcast.net
64298 9 months ago
hello friend, could you help me find the same effect? i would need some help in my experiment. how can i speak with you?
Sumermagor 9 months ago
This is all still measured incorrectly. Overunity is not possible. Your fabricating skills are very good, I wish you and other talented people like you would stop this waste of time and put it toward improving efficiency and learning the proper ways to measure your ideas. Your DC amp clamp is not correct because this is not true DC. All your measurement methods are incorrect. This is a shame, because you have some great ideas, but you are looking into the sun instead of harnessing it.
rostit420 9 months ago
@rostit420
I have moved on and am now concentrating on a WORKING SMOT like motor that runs continuously.
Dont need any testing to at all as the model is very powerful and not only will it turn continuously it can power other devices. A quantum leap from what i have been doing. Hope to post all when I dress up my model for presentation. It can run untill both magnets loose their magnetic power or untill the earths gravity stops functioning. Yes its not perpetual motion.
64298 9 months ago
Very cool!!
How can I get a hold of you? I don't know rules? I would like to talk to you.
AUTS4U 9 months ago
@AUTS4U Send me an email 65t@comcast.net Mention AUTS4U
64298 9 months ago
Hi Tom,
please retry the measurements by replacing the LED bulb
with a 275 Ohm 5 Watt resistor and see, if you get the same voltage and current on it.
Also use a low pass filter at the 12 Volts DC input to measure the input current.
WIll be interesting to see, if you will get the same measurement values.
Also do you get more power out, if you put the magnet ball inside the coil
or if you put it ontop your coil ?
Many thanks.
Regards, Stefan.
overunitydotcom 9 months ago
@overunitydotcom Working on the SMOT loke motor device presently.
64298 9 months ago
Is the spinning magnet rotating while spinning - if not, what i`m thinking is : if you build a small coil with a spinning magnet inside as a unit, then place the unit onto the big coil, so that the big coil do the spinning work, one can capture xtra energy from the little coil as well as the big coil ?
bennjanse 10 months ago
Very good - the magnet is in sort of resonance with the rest of the circuit - you take the magnet away, resonance stop - circuit die. Impressive !
bennjanse 10 months ago
@bennjanse I recently found an even better way to produce more light output with almost perfect resonance than the test tube magnet. Found smaller magnets work best to a certain point then they dont work at all.
A 7 mm diameter diametric ring magnet -20 mm in lenght works best so far - suspended on a 25 pound nylon fishing line over the coils center hole. Its fantastic!
64298 10 months ago
what circuit to run the coil .
theonethatgoofs 10 months ago
@theonethatgoofs Check the SPLISH SPLASH Video where I have posted many build links including the circuit under PhotoBucket.
64298 10 months ago
neat, thanks for sharing, now my head is spinning like that ball!
harrisonbee 10 months ago