Arm for a humanoid robot controlled by xbee

[inspiredStudent]

how do you wire it without a shield?

[moulanaaaa]

pleas tell me this motors details

[moulanaaaa]

pleas tell me how to do this

[Airbusftw]

Hi, can you help me out. I am trying to communicate the Xbee modules together but I can't. I have a much more simple setup then you do, I am connecting an 8051 with the Xbee transimetter and the receiver is connected with a PC. Any help would be great pls since I can see you worked with a micro too :).

[romancanas]

Sure, describe a little bit about what you are doing

[Airbusftw]

I made a portable waether station, and am trying to send the serial data from the micro to the PC. The serial UART data that I am sending it in HEX, for example. the Temp sensor reads 00010010, the 89C51 converts that to hex and sends it through the TX pin.

I have updated the Xbee firm ware by using the X-CTU software, I connected the Coordinator(xbee) with the micro where micro's TX goes to xbee's RX pin, all supply and inputs to xbee are at 3.3V. Still can;t receive anything to the PC.

[romancanas]

Which baud rate are you using for the microcontroller's serial port ? Is the microcontroller sending data to the Zigbee ? perhaps you can take a look with an oscilloscope

[chemistrycoolguyscom]

how do you made one the same ? what so you need

[arximidisxeno]

Bravo!!!

[ramesh226]

can u spare some manual of this

[fallenspirit123]

this may sound so noobish I never used a servo before, where can I get that mounting hardware you used? or is it custom?

[thiegonunes]

I bought the modules xbee, but can not do their configuration, Do you have some manual configuration of modules?

[pymyhometown]

well done mate.what language do you use to control the servos?

can you share your code with us?

[MTG115]

What is xbee?

[chris91494]

hey! what type and volt motors? are they servos?

[romancanas]

Yes, they are Hitec HS-311

[philwinder]

Nice work! Want to see a full xbee robot next! Also, blog your work!

[romancanas]

Thanks !