PIpe Beveling | Beveling Pipe

[joetkdchamp]

Machines heart is in the right place bless it. But if your a pipe welder it better to do with a grinder to get even Walls.peace

[MrFatheroffive]

Try lugging that up into a piperack and doin a cut in.

[snakeyes7711]

@Blazinloud, HA No doubt!

[EmberToInferno444]

What a thrilling career

[Jrexjr]

I prefer my 4" dewalt any given day.

[blazinloud]

clearly 4 inch pipe. and real fitters do it by hand. that land looks terrible

[dougspair]

@blazinloud ..Yes...certainly not 6"...and I thought the land looked bad too...

[Jigaboo123456]

@dougspair Yeah the land looked nearly non-existant on the right hand side.

[carlsonpotts]

look mom no hands...good luck with a 20 ftr, solo before break. give it a turn in your hands so we can see the other side of the landing too, lots of glare in that nice clean shop.looks a little sharp on the near side, xololol

[poorcncoper8or]

Thats awful small 6.0 inch

[1972austinlee]

Bettter turn that welder up hott. To break them walls down.

[MrCharlievert]

avec une meule on peut faire quand on est doue de ces mains t imagine si faut ramener ton appareil sur un chantier ca fait lourd pour les bras

[dbennett4]

Nice 3/16 land on that stainless! Feather edge might work a bit better...

[uksupertrucks]

gimmie, gimme one of those suckers