Fordenergy, how big of line are you using on your out bound line?. Most of the videos I've seen are using 3/8" line, do you think a smaller line is better?
Yea Ive had just a few thoughts LOL, There are a few ways to increase output that Ive read about, and intend try. 1) Frequency modulation 2) Magnetism 3) Running air from an outside source through the cell (ie intake vacuum ) 4) Vacuum pressure on the cell (Ive already tried this and there is no change, if you viewed my video on it - that had a leak so the results were wrong. I pulled that video I didnt want to misslead anyone.
Well i would use the top of my bubbler to connect to an engine or whatever not glass. This setup was just to measure output from the cell. THe gasket is just a rubber O ring from a hardware store. As for enough gas, it would not run long. Again this is just my test cell I hope to build a large series cell after I figure out the most efficient way to produce gas.
I think its cool Jack nicholson is involved in HHO research. lol.
adex02 3 years ago
Fordenergy, how big of line are you using on your out bound line?. Most of the videos I've seen are using 3/8" line, do you think a smaller line is better?
hydrogenassist 4 years ago
Yea Ive had just a few thoughts LOL, There are a few ways to increase output that Ive read about, and intend try. 1) Frequency modulation 2) Magnetism 3) Running air from an outside source through the cell (ie intake vacuum ) 4) Vacuum pressure on the cell (Ive already tried this and there is no change, if you viewed my video on it - that had a leak so the results were wrong. I pulled that video I didnt want to misslead anyone.
Fordenergy 4 years ago
Well i would use the top of my bubbler to connect to an engine or whatever not glass. This setup was just to measure output from the cell. THe gasket is just a rubber O ring from a hardware store. As for enough gas, it would not run long. Again this is just my test cell I hope to build a large series cell after I figure out the most efficient way to produce gas.
Fordenergy 4 years ago