HELP: When i go to pull my pull start and it fulls like its jammed, it would break your arm trying to pull it.. when i pull it the bike lifts up even when im holding it down... what wrong with it ? Plus i cant find an allen key to fit the pull start cover to get it off. I used to race it around different gokarting tracks but its been felt for about a month or so, i dont think thats got anything to do with it though as it started fine last week when i had a little run on it.
someone please help me i just bought my new mini moto dirt bike and when u pull the pull start it just makes a ruselling noise then thats it pllllsssssssss heellpppp mmmmeeeeee ppl
Could be the carb, blocked fuel line, pressure in fuel tank or spark plau. Our FRE pocketbike manual will help you, you can get to the download via my profile
OK listen. Simple fix all you have to do is go buy some carburetor cleaner and take the carburetor off the mini moto and clean the carburetor. There are videos on youtube to show you how.
had the same problem yo i got the saluuuuuuuution put ur legs on the pulling thing and pull it sooooo hard it worked for mee im soooo happy tell me if it worked
try walming the engine up with an airdryer ..... i had the same problem ... the pipe going from my tank to the engine hade a kink in it .. look at that pipe . good luck
ok, i have a the same problem i think, there should be a 2 rubber gaskets stoping water getting onto the spark plug in the engine, the rubber gasket or ceil is worn out or ripped or something
try giving it some throtle or make sure the spark plug has a spark and make sure there is fuel going through the carberetta properly and make sure that there is nothing wrong with the air filter/carberation
hi m8 put some petrol in the spark plug and put it back in and it will fire and then do it agen and then it should run and when it fires up (run) rev it and don't let it stop until it will tick over ( i have had about 8 of there and they are all the same ) . please let me know how u get on with it
i did that touch check, any how i pourded a little bit of the fuels mix into here, im not going to say how much because i guessed n i told my mate a amount but his mini moto took off down the road, i kept doing this and it eventualy started but cut out, i started adding more and it started running longer, then i ran alongside it once it was started to remove strain on engine from the clutch, finaly i added more fuel then it was pulling my mate along, then it got a burst of power
bought a mini motard £10 it hadnt been run for 3 years there wasnt a bright spark coming from it and i beleive the carb was block as there was barely any fuel in the cylinder after i had been pulling it for ages, some one on this said to check the spark but how they said to check it isright but you need to make sure the metal bit where the spark jumps is touching metal,
@mojospin HI m8 to make sure your carb isn't blocked up undo the little bolt under the carb where the float goes and it should trickle out and if it does for at list 1 min then its not blocked and then put some petrol in the spark plug and then put it back in and it should fire up . let me know how u get on with it m8
try taking the spark plug out and put it back in the ht lead and then pull it if it has a spark you know it isnt the spark plug but if there is o spark try replacing the spark plug.
The reson why it wont start is cause its a chinese piece of shit... I got a pocket bike (its chinese) and it worked for 2 days and then it stopped workin... I brought it in to my local powersprts place and they fixed it... It was just a bad carburater... Ever since i got it fixed its been runing great
well for a start the bike should start second pull at most and u may need to change the magnets if there is no spark but ur bike looks awesome. or the mix might be wrong.
@TheMircea83 guys what u should do is if u have s stroke pre mix oil u need to get a new spark plug cas it would be cloged or u need a new pull start cas im very good with bikes i got a workshop for them if i see it than i would probly find the problem and if u want fit a 100cc engine
HELP: When i go to pull my pull start and it fulls like its jammed, it would break your arm trying to pull it.. when i pull it the bike lifts up even when im holding it down... what wrong with it ? Plus i cant find an allen key to fit the pull start cover to get it off. I used to race it around different gokarting tracks but its been felt for about a month or so, i dont think thats got anything to do with it though as it started fine last week when i had a little run on it.
iNafeH 5 days ago
chek for a spark it may be the coil or spark plug
bmxing3449 1 week ago
make sure the fuel mixture is right then try twisting the throttle while pulling the chord
SHOOTINGMACK 1 week ago
beside the "choke up" there is a little pedal looking thing. pull it up and down like three times then restart the normal process
rotsebanotman 3 weeks ago
try pressing gas while pulling the string for the engine
rotsebanotman 3 weeks ago
your not putting any throttle on....
JordzMaytee 3 weeks ago
someone please help me i just bought my new mini moto dirt bike and when u pull the pull start it just makes a ruselling noise then thats it pllllsssssssss heellpppp mmmmeeeeee ppl
windmillcity1 1 month ago
Could be the carb, blocked fuel line, pressure in fuel tank or spark plau. Our FRE pocketbike manual will help you, you can get to the download via my profile
Pocketbikemanual 2 months ago
OK listen. Simple fix all you have to do is go buy some carburetor cleaner and take the carburetor off the mini moto and clean the carburetor. There are videos on youtube to show you how.
zeltrax3000 2 months ago
the fuel tap wasnt on!
connormck1996 3 months ago
2 Stroke always works for me
iXTwistyXi 3 months ago
clean out your carbaretour and you have to put a lid full of 2 stroke oil in with the petrol
1on1MClovin 4 months ago
that the best help you going to get it from me and take some oil out it will be runny and then you got water in the engine
ashboy225 4 months ago
right naw i know what to do it has got water in that fueltanor water in the oil i has hapend to me on my dartbike
ashboy225 4 months ago
or your spark might of got abit wet so get it checked thats probly why it wont start
SuperAlfiem940 5 months ago
make sure theres fuel and check your carb it might have a lil crack inside it if it does buy a new one or just put a lil bit of super glue
SuperAlfiem940 5 months ago
This has been flagged as spam show
had the same problem yo i got the saluuuuuuuution put ur legs on the pulling thing and pull it sooooo hard it worked for mee im soooo happy tell me if it worked
fazeelur888 5 months ago
YOU LEFT YOUR CHOKE ON....
forresterL11 6 months ago
try walming the engine up with an airdryer ..... i had the same problem ... the pipe going from my tank to the engine hade a kink in it .. look at that pipe . good luck
brandon99111 6 months ago
mines seized but i dont know where to get it fixed ?
footygirl99 7 months ago
have you got 2 stroke oil in it mixed with the petrol
453thomas 7 months ago
ok, i have a the same problem i think, there should be a 2 rubber gaskets stoping water getting onto the spark plug in the engine, the rubber gasket or ceil is worn out or ripped or something
darksariman 7 months ago
its seized maybe?
IIDaZZo55IIMONTAGES 7 months ago
well u should try cleaning the carb or you might of blowen your motor or another this you can try is to give it some gas while pulling the pullstarter
i hope this could help your problem
ryananderson71 8 months ago
1 word: chineese
d567joker 9 months ago 2
@cooldude1752 i have a mini moto superbike style and its a complete mess I need a new engine and back wheel
spotz2k7 10 months ago
no gas going into the carb
123candystand 10 months ago
try giving it some throtle or make sure the spark plug has a spark and make sure there is fuel going through the carberetta properly and make sure that there is nothing wrong with the air filter/carberation
number1YMASfan 11 months ago
ino learn to acctullay pull a pull starter u dragin the bike and give it some gas when pul not to much cause u will flood the engine other wise
TheFunnyPark 11 months ago
hi m8 put some petrol in the spark plug and put it back in and it will fire and then do it agen and then it should run and when it fires up (run) rev it and don't let it stop until it will tick over ( i have had about 8 of there and they are all the same ) . please let me know how u get on with it
josh891995 1 year ago
fuel lines FUCKED mate
corkguy09 1 year ago
twist the throttle as you pull the chord
hjfreerunners 1 year ago
its not fireing go tyr cleaning ur ghd the thing ontop of your sparkplug and strip down ur crab and clean it
DGOxR3C0N 1 year ago
iv got the same problem mate i dont have a clue about what to do aswght need to ag et a new spark plug
raja786pk 1 year ago
because of crap being removed from the carb n it flipped, started it up lifted the back end and kept reving it and it ran perfectly
mojospin 1 year ago
i did that touch check, any how i pourded a little bit of the fuels mix into here, im not going to say how much because i guessed n i told my mate a amount but his mini moto took off down the road, i kept doing this and it eventualy started but cut out, i started adding more and it started running longer, then i ran alongside it once it was started to remove strain on engine from the clutch, finaly i added more fuel then it was pulling my mate along, then it got a burst of power
mojospin 1 year ago
bought a mini motard £10 it hadnt been run for 3 years there wasnt a bright spark coming from it and i beleive the carb was block as there was barely any fuel in the cylinder after i had been pulling it for ages, some one on this said to check the spark but how they said to check it isright but you need to make sure the metal bit where the spark jumps is touching metal,
mojospin 1 year ago
@mojospin HI m8 to make sure your carb isn't blocked up undo the little bolt under the carb where the float goes and it should trickle out and if it does for at list 1 min then its not blocked and then put some petrol in the spark plug and then put it back in and it should fire up . let me know how u get on with it m8
josh891995 1 year ago
try new spark plugs if not check the exhaust for a blockage if not clean the carburetor
RCDUMMIESRC 1 year ago
pull the throttle a bit a pull cord at same time
TheMinimotoguy 1 year ago
The carburetor needs cleaning veryy good cleaning
giannis988888 1 year ago
Hey try electric starting it. Get a jump starter and wire it up to the the spark plug
umar1999 1 year ago
try cleaning out the carb jets, take the float off and there is a gold jet push a thin bit of in there after taking off throttle cable
TheMrgokartcrazy 1 year ago
buy some easy start
NBKxSniiperZB 1 year ago
when pulling it give it some rvves when the choke is downe
benT4100 1 year ago
add more petrol and make sure its full it might work then
kittenman911 1 year ago
try taking the spark plug out and put it back in the ht lead and then pull it if it has a spark you know it isnt the spark plug but if there is o spark try replacing the spark plug.
whuarethebest 1 year ago
The reson why it wont start is cause its a chinese piece of shit... I got a pocket bike (its chinese) and it worked for 2 days and then it stopped workin... I brought it in to my local powersprts place and they fixed it... It was just a bad carburater... Ever since i got it fixed its been runing great
puckhog987123 1 year ago
well for a start the bike should start second pull at most and u may need to change the magnets if there is no spark but ur bike looks awesome. or the mix might be wrong.
iiShOKZz 1 year ago
haha the first thing you called the choke is the petrol tap LOL
try cleaning the carb, after all you have put a road filter on a off road mini moto
fatalproductions32 1 year ago
did you mix the petrol with two stroke oil ?
theoneonlybean 1 year ago
MY POCKET HAS THE SAME PROBL,I JUST GOT IT AND IT WONT START I DONT KNOW WHAT 2 DO..HELP ME PLS!!!THNX
TheMircea83 1 year ago
@TheMircea83 have u ternd the key
hod1652 1 year ago
@TheMircea83 guys what u should do is if u have s stroke pre mix oil u need to get a new spark plug cas it would be cloged or u need a new pull start cas im very good with bikes i got a workshop for them if i see it than i would probly find the problem and if u want fit a 100cc engine
cooldude1752 1 year ago
pull it as hard as you can
pump the fuel
have you put oil in ?
hashcock 1 year ago
have given it bk to the people to fix and they havew had it for a week as they cant get it started yet
hod1652 1 year ago
put some fuel in!!!!!!!!!!!!
squirrel6158 1 year ago 4
@squirrel6158 there was some in there
hod1652 1 year ago