Newman machine replica

[hongkypongky00009]

any one .. what is the meaning of 9v battery? 9 valve?

[MPaulHolmes]

That was cool!!!

[ibercaracole]

I am not familiarized with the concept of Joseph Newman

it it valuation that it to have established possible a schema pours fulfil the same model?

Thank you

Pierre, Benicassim Spain

[kmarinas86]

With the beginning of a wire, use some watch batteries to draw a small current and then connect the end wire to a car battery. I would love to see watch batteries being used to power any size motor. That will be a lot more impressive to me than the use of the typical 9V or 12V batteries beings used in these videos. 1 kg * c^2 = 2.49654216 * 10^13 watt hours ... peace <3

[labidus74]

one go to the negative side of the battery and the other touch the shaft, on the shaft they are some tape that fake a commutator and on one wire from the positive side of the battery always touch the shaft (white wire)

[garpike2007]

Hi Labidus74, Nice video! Question: where does the ends of the coil go, one is for the points (inner or outer wire?) and the other goes where? Also, the points in relation to the magnet orientation?

Thanks

[dekree]

any way you can describe your magnet array setup? I see Chuck uses two ring magnets in a single cycle setup(i thinks thats how to say it) thanks soooo much :)

[labidus74]

same as Chuck, I used 2 rings magnet from a old microwave !

[chuck2na]

great replica you even with the flower pot

thanks for replicating my machine and i will post more on what its all about now

sincerely chuck2na

[dekree]

Is the coppr wire for your coil insulated wire? or bare copper?

[labidus74]

insulated wire

[labidus74]

1mm, but mine is not doing any overunity, its really efficient but i cannot recharge any battery with mine, prob because i need more wire and a bigger magnet, or make the coil smaller in diameter, my flower pot is to big for the magnet

[dekree]

how many windings did you do? or how thick?

[labidus74]

i don't know sorry, more you have wire more it's better

[groanoke]

Right.I used 12 gauge wire and 4 small neodymium magnets (2 on each side--I just wrapped the axle center with electrical tape).My coil diameter to magnet ratio seems off like you were saying. Also, the metal rod I chose for the axle doesn't conduct well! So much for quick lazy setup! Maybe working with Chuck we can figure out the correct ratios.

[labidus74]

visit overunityDOTcom

search for newman for more info, replace the DOT by "."

[groanoke]

What size wire did you use ?

[ruuuuuuuuuuuuuuu]

Enjoy recharging your batteries! ;-]