HAM International CONCORDE II HAM/CB-Radio by Cybernet

[TheLASERJAW]

Great radio. Great video. Thanks.

[SWIZZRADIOS]

@TheLASERJAW

Hello dr OM, thank you for the comments..You're welcome...Best 73's...

[irnmadn99]

good looking radio....happy air waves to you.

[SWIZZRADIOS]

@irnmadn99

Also the best 73's to you and yours...Good luck...

[Seanobs]

Hi, I bought a Concorde 2 and when I go to tune the SWR, the needle jumps back and forth after the mic is depressed on an external meter. I try to adjust the CAL on the external meter but the needle still jumps around. I have tested the cables and antenna. Any suggestions? Thanks in advance. Sean.

[SWIZZRADIOS]

@Seanobs

Hello dr CB fan. Open the box and clean the SWR-CAL-pot & the SWR/CAL/RF-switch with WD40-spray. Then it will be OK...Best 73's...

[dividebyN]

I'm selling a full set-up on eebayy right now.

Concorde multi-mode Mk1, original mic, K40 speech processor mic, K40 mag-mount, LA-120 linear amplifier with in-built rx pre-amp, HFC-01 counter, hs-100 10A P.S.U, 1Kw low pass filter, lightning arrestor, TWO long RG58 cables with pl259's, pl259-R.C.A. for counter. The tranceiver has its original BOX AND WARRANTY ! The k40 mic is in its original box. The linear has its box. This uses a PTBM059 chassis.....

[SWIZZRADIOS]

@dividebyN

Hello dr seller. What's the difference betwin the Concorde 1 and 2 ?... Thank you....

[dividebyN]

@SWIZZRADIOS : Hello ! I'm not 100% sure the difference, (apart from the obvious fact the chassis is different) !

The chassis in my transceiver is a PTBM059COX chassis. I haven't looked at the spec for a MK2 yet ! If I remember rightly though, I think the front panel is a slightly different layout.

Is this a trick question ???

lol !

[SWIZZRADIOS]

@dividebyN

Ok, I think the MK1 does have the PTBM059 Board. Thank you for your comments. Now. I'll take a look into "eebbyy".....Thanks & 73's...

[dividebyN]

@SWIZZRADIOS ; OOOPS !!! Duh ! YOUR rig on this vid is a MK2 !!!...lol....ooops....and yes, it is a different layout ! As far as I know it uses a PLL02A and has a crystal filter so I'm unsure what the difference is apart from coverage !

Cheers !

[teamfab]

Next on my list is a nice Concorde, great lokking radio..

[SWIZZRADIOS]

@teamfab

Hello my friend..

Of course, this is really a beautiful rig. The roger bleep sounds like a bird. (but not at all PTBM121's)

Good luck... 73's de Stef..

[darynsax]

This was my first ever ssb radio, wish I had kept it now

[SWIZZRADIOS]

@darynsax

HELLO dr OM,

I think, the PTBM059 is bether in the S/N characteristic, than the PTBM121/125 and others. In the RX path, I 'm missing the big 10.7 Mc X-tal filter. The AM/FM RX, is very noisy.

73's de Swizzradios

[antekmasakrator]

excellent radio!! I have similar... I am inviting to my channel!!

[SWIZZRADIOS]

@antekmasakrator

HELLO my friend,

I think, the PTBM059 is bether in the S/N characteristic, than the PTBM121. In the RX path( PTBM125), I'm missing the big 10.7 Mc X-tal filter. The AM/FM RX, is very noisy and wide.

73's de Swizzradios

[darynsax]

My first ever multi mode cb radio

[SWIZZRADIOS]

@darynsax

Hello my friend. My first ever multi mode cb radio (1982) was a SUPER STAR 360FM (PB010). But the receiver was very weak and the S-Meter had also weak S-levels. Oh no.....

[Strawberrycream69]

Wow! what a beauty : x

[SWIZZRADIOS]

@Strawberrycream69

Of course, but the Concorde3 is a very noisy box, because the X-tal filter 10.7Mc, is just made for SSB.Hi Hi.