HHO Generator 9 plate system

[thegreatkoua]

glass jar is suck it tell you. i blow a few of those.

[ILLSANFIC]

Once you begin making the hho how do you gather and store it? Or do you just use it as its produced? Im new to all this.

[shamansays]

You use it on demand. no storage

[Plichtam]

It'd like to see an ampmeter and a volt meter in your next vid. See if the gas you are giving off is enough to power a generator to make back the same power you are expending. I've seen a few projects that focus on high output for low voltage and some that "pulse" the electricity to get a better reaction for less power. High voltage is needed for the seperation, but if you can limit the amps, your overall consumption of power is very low.

[shamansays]

Well if you add in the power that I myself expend into building these things , you will see that they dont come close!There are enough variables as well as combinations in the"hho production" department that some things get pushed back on the "things to test" list.I just want to know what the resonate frequency of water might be.I suspect that if distilled water does not carry a current, then it might not have a specific frequency either.

[uawwildbob]

have ya tried no neutral plates and tightin up the gap then no electrolyte. gap at twenty thousands have fun with it. I did

[BLONDININZ]

Hi, Keep up the good work. I have a 5 plate system that i am building with cable tyies between the plates but it heats up the water pretty fast. HELP.

Thanks

Chris (New Zealand)

[shamansays]

It depends on a couple of things, how many amps, how much electrolyte, loose connections, too small of wire.

Iwould need to know more to really help.

[kauboy9816]

Question... why did you decide to have more positives than negatives?

Hydrogen is produced off of the negative plates, and Oxygen off of the positives.

Depending on the steel you're using, the positives will tend to oxidize and rust faster, plus the added Oxygen only makes your computer get confused on the air/fuel ratio.

I'd try to limit the amount of O2 you put off by having more negs than pos.

Just a suggestion.

[shamansays]

I am certain that you can not produce more of one gas than another.If you are releasing hydrogen from the h2o molecule, then you must be releasing the oxygen as well.Two hydrogens one Oxygen. If isolating the two gases is what you want to do, there is a simple aparatus for doing just that. Hydrogen will only be carried to the side of the neg plate that is closest to a pos. By doing this you are providing more surface area for the process. Hope this was helpful.

[Vistal1]

the sodium hydroxide seem to eat the tool dip over time and produce foam we stoped using it and went to SS Straps yo the top of the container.

[dreamwhileyousleep]

What is your electrolyte? Why do you need neutral plates? Nice production, three at the same time could be 10 L/min if the alternator can handle it.

[shamansays]

In the video I am using baking soda, but I usually use sodium hydroxide. Its not likely that I will use all 27 in my truck, I will probably make a cutting torch with the left overs.

[shamansays]

The neutral plates do two things, first they produce hydrogen on both sides, two they reduce the amps one quater for each plate.

[MechanicalBunnycom]

Looks great! Keep up the awesome work!

:)