looks good, i bought a poor man jig befor i knew i could make one and it sucked. my mag well didnt bend at all they poped out and had to smash with hammer. the steal for the sandwich should have been wider on the one i bought.*You did great
@ioak47 thank you. i was worried about the mag well opening, an issue i take it a lot of people had with the old tapco flats. i never had an issue i just clamped the crazieness out of it.
@agumon12 It was one of those 80% tapco receivers that are no longer in production. Ak builder flats seem to be the only option. Did you have a problem with the rails?
looks good, i bought a poor man jig befor i knew i could make one and it sucked. my mag well didnt bend at all they poped out and had to smash with hammer. the steal for the sandwich should have been wider on the one i bought.*You did great
ioak47 2 months ago
@ioak47 thank you. i was worried about the mag well opening, an issue i take it a lot of people had with the old tapco flats. i never had an issue i just clamped the crazieness out of it.
vipergts333 2 months ago
I am inspired to build an ak receiver now. can i use that jig ? rent it from you maybe?
famasdan 2 months ago
@famasdan it would cost less to just build the jig yourself. if you were local i would let you borrow it.
vipergts333 2 months ago
how much did i cost? i understand it but my sound driver fucked up and i cant hear shit.
havanabob420 2 months ago
@havanabob420 total without mags around $270
vipergts333 2 months ago
@havanabob420 the bender only cost around 15 in materials however...
vipergts333 2 months ago
Hell of a lot better than my reciever which ahem... didn't work... :/
Where did you get the blueprint on to build this?
agumon12 6 months ago
@agumon12 It was one of those 80% tapco receivers that are no longer in production. Ak builder flats seem to be the only option. Did you have a problem with the rails?
vipergts333 6 months ago