Ismael Aviso Tech Ambient extraction basic principles part 2 / 3

[blaircolon36]

I want this video on my OT-910 phone.

[beverlybradley210]

This vid is a favorite on Dominica

[Khwartz]

Ismael have made a little error too, but looks not change anything about if its really work or not: is meter is in mA and reads and wrote in Amp. But I very appreciate the video any way, and I really feel is sincerity. Could be his mistakes are just because could be hard to think to everything, but I real feel him sincere to show and explain everything.

[Khwartz]

@cristian91re I had same remark to do, and he should have disconnected the capacitors before.

The problem too the english uses the word "power" for real electrical power, like P[W]=I[A]*U[V] while here it's VERY IMPORTANT to differentiate both!

But even real electrical power in not enough to check, energy used in and output is important.

In one of his video showing his car, the capacitors, fully charged, could run a 11kW car for 30min, what he only ever success to do.

But he could be sincere.

[cristian91re]

why you don’t show how much current flow out by the "black box"?? 1000v it's nothing if amp are 0,05... i can work whit some tesla coil, and give you a 1000000v :D!

[w23trhfyer]

those ambient energy collectors must be proven in various ambients/regions/states, because the electromagnetic pollutions in various states are not the same.. This could be a big radio amplifier circuit, which, without intermediation of transmitters or power lines may not work .. and free, could not be completely free

[jburnum]

Take note, the generator coil that sits just below the low resistant tesla primary! The generator coil is what is creating the A/C wave on the primary. All solid state, no magnets to creating the A/C wave! Just the oscillating magnetic field of the generator coil below. Tests have been proven that you reduce the input draw DRAMATICALLY by shorting at peaks and troughs of the A/C wave. But again, the lower the resistance by using parallel bridge and parallel fets/igbt, the more recovery.

[jburnum]

Amazing work here! Low impedance switching is key to getting the energy out of the shorting coil process. Why not add additional diodes in parallel for bridge to get more efficiency gains?

Does any one know were you can find or build a very efficient...95% or better inverter at these higher freq?

Thanks, Jeremy

[TedFnBuckle]

kinda beyond lost here, there aint any wats behind it, and isnt these messurements in milliamps lol.