that was a sweet vid. do you think you can post a longer vid of it milling that part? or a different part. im thinking of getting a Sherline but would like to see how fast they perform.(or rather their capabilities.)
I'll post another video next weekend with a round part machining 3 flat areas using a rotary table to revolve the part (4 axis machining). I don't recall exactly (traveling till Thursday) but I think the cuts were done at 5 inch/minute and the "rapid" move to and from the hole were done at 10 IPM. Sherlines don't run well above 20 IPM...
How do you like the A2Z parts?
YoungJim409 1 year ago
@YoungJim409,
I think they have good products. The quality has been good for me so far.
rdgtm 1 year ago
Great machines, thanks for sharing the video.
vlmarshall 2 years ago
Is this at work? How much will cost a setup like this?
bigbattles 2 years ago
can you do tap holes with this machines?
rosaliomorenocervant 3 years ago
Yes, search for "thread milling" on google and youtube...
rdgtm 2 years ago
thanks for the tip!!!
nice video good work!!
rosaliomorenocervant 2 years ago
kool, im looking forward to the next vid :D
thanks for the info.
canbaja5 3 years ago
that was a sweet vid. do you think you can post a longer vid of it milling that part? or a different part. im thinking of getting a Sherline but would like to see how fast they perform.(or rather their capabilities.)
canbaja5 3 years ago
canbaja5,
I'll post another video next weekend with a round part machining 3 flat areas using a rotary table to revolve the part (4 axis machining). I don't recall exactly (traveling till Thursday) but I think the cuts were done at 5 inch/minute and the "rapid" move to and from the hole were done at 10 IPM. Sherlines don't run well above 20 IPM...
rdgtm 3 years ago