Got both of the SD40-2's today! They look great! I'll run them in a couple weeks & see how they work with my MRC "squared" controller. Thanks for programming them also!
Im going to have to look into these MRC DCC things. I have this Locomotive however it makes it 100% better with the sound. I use this locomotive to hull Bethgon coal hoppers. Thanks very much for posting
I have a kato sd40-2 but it won't give me sound do I have to buy something for that
steviiboy1 3 weeks ago
This has been flagged as spam show
I may sound stupid because I'm new to upgrading my dcc, but how do you operate all the engines in the consist at once? Thanks
Giandotcom1 2 months ago
I may sound stupid because I'm new to upgrading my dcc, but how do you operate all the engines in the consist at once? Thanks
Giandotcom1 2 months ago
gerat !!!!
gartenbahner 7 months ago
how much do theese cost
btafire2 1 year ago
what sound decoders were used in this one?
ModalTrains4884 1 year ago
you broke the coupler on that car ,UR FIRED !!!! Or pay 2,000 for the coupler
trackspike64 1 year ago
where on earth do you fit the speaker ?
sidney001 1 year ago
@sidney001 The speaker is built on to the dcc decoder board. They are small!
DCCinstalled 1 year ago
they need to try again with the sounds
bricub72 1 year ago
@bricub72 N Scale sounds are not there yet... companies like Soundtraxx are starting to get into N Scale to the sound should be improving!
DCCinstalled 1 year ago
i know this is probly a stupid qestion... but is there a size diffrence in ho and n? i know there is sposto be a detail diffrence.
xodgpc 2 years ago
N Scale is half the size of HO Scale..
N is 1:160 and HO is 1:87
DCCinstalled 2 years ago
@xodgpc HO is 1:87 and N Scale is 1:160 The details in N are getting better.
DCCinstalled 1 year ago
will this work with the Bachmann Ez-Command System
RumbleFighterMan 2 years ago
Yes it will work with EZ command. The address would have to be programmed to address 1-9 unless you have the Dynamis.
DCCinstalled 2 years ago
do NOT get any DCC system by bachmann, i got the dynamis and had to sell it because it was so hard to use. get the digitrax zephyr
rockguitarist946 2 years ago
Got both of the SD40-2's today! They look great! I'll run them in a couple weeks & see how they work with my MRC "squared" controller. Thanks for programming them also!
GP9railfan 2 years ago
you are on the whistlepost and I am mattboy on the whsitle post
familyguy24680 2 years ago
Im going to have to look into these MRC DCC things. I have this Locomotive however it makes it 100% better with the sound. I use this locomotive to hull Bethgon coal hoppers. Thanks very much for posting
LocalRailfan 3 years ago
This comment has received too many negative votes show
Too bad you can only use #6772 if you model 1990-1992.
BobbySimone86 3 years ago