Cylinder Honing

[SkinnySkinch]

1200 rpm max is usually the recommended limit for a honing.

[trikes4life8256]

1st off ur not suppose 2 use an air tool it runs at 2 high of an rpm 2nd mistake u want the little scratches ur puttin into it at a 45 degree angle witch i can clearly c ur not doing this is so that ur rings seat better

[bigboy29033]

I have a 6 cylinder block if I use this process I am going to write now is it good :

first I am going to use that type of tool that this guy used than I am also going to go on a flex hone tool is this process the right way ???

[MrGringoPy]

Your dont push the honing tool deep enough. It must come out the bottom as well !!! Over shoot should be 1/3 of the stone on both ends.

[gtyamaha]

can you please explain to me what this does? i have a cylinder that has shiny spots on it, would i hone it to get it fixed?

[sixty9below]

You're an idiot..

[maxpaul11]

Are you tryin to bore it

[sixty9below]

No, it was being honed so that new rings would seat correctly

[perucane]

is enough this process?

[newcomer9747]

how much can i buy this shit for?

[IamShipon1988]

Finally something to help me with this engineering class project. Thank you very much for the video.