hey kavisi, I have a slash 2wd with a 2200kv mm ( tight fit i know) where do i get the pinion and spur gear you have that might fit a slash thanks awesome vid
@killaanissan thanks. Never owned a slash. Just looked at the exploded view and you should be able to run a rustler tranny. Spurs from integy. Once at the site search for T3178. Pinions, eBay or rcmonster. They should all be mod 1.
I had the same problem until I drilled out the drive shaft hollow pin and used a Traxxas 2754 Stub Axle Pin. I have a CC MM 2200kv system and I have not had any probs since.
@kwikdubbzdevo thanks. It helps a little too much. Eating into the Max speed. Time to start reducing weight litttle by little. The sound it makes; priceless!
@Johnracerx All thanks to you. Followed them to the T. Paint job err main intention was visibility :) didn't clean before painting so came out bad, up close. Well its going to be a long wait for my 35t. Fingers crossed.
Where what's the name of them tires and rims
waliwhite1 2 weeks ago
@waliwhite1 They are GRP soft mounted tires.
kavisl 2 weeks ago
where did you get the tires an rims from?
MrWelch313 1 month ago
With a drill bit. Just match the bit and the axle pin.
04toys 1 month ago
looking good !
giostealthr1 1 month ago
@giostealthr1 thanks Gio
kavisl 1 month ago
hey kavisi, I have a slash 2wd with a 2200kv mm ( tight fit i know) where do i get the pinion and spur gear you have that might fit a slash thanks awesome vid
killaanissan 1 month ago
@killaanissan thanks. Never owned a slash. Just looked at the exploded view and you should be able to run a rustler tranny. Spurs from integy. Once at the site search for T3178. Pinions, eBay or rcmonster. They should all be mod 1.
kavisl 1 month ago
@kavisl Thanks man, just another question... Will a normal pinion (19tooth)fit the mamba monster shaft? or is the pinions hole to small?
killaanissan 1 month ago
I had the same problem until I drilled out the drive shaft hollow pin and used a Traxxas 2754 Stub Axle Pin. I have a CC MM 2200kv system and I have not had any probs since.
04toys 1 month ago
@04toys John and I were talking about doing the same. How did you widen the cutout/groove on the idler?
kavisl 1 month ago
@04toys John and I were talking about doing the same. How did you widen the cutout/groove on the idler?
kavisl 1 month ago
Nice runs mate it looked a lot faster than 70
BulldogMatt22 1 month ago
@BulldogMatt22 thanks. Well didn't have the radar gun out, too lazy, but the forerunner is pretty accurate at that speeds :)
kavisl 1 month ago
absolutely fabulous work man. how much does that front spoiler help?
kwikdubbzdevo 1 month ago
@kwikdubbzdevo thanks. It helps a little too much. Eating into the Max speed. Time to start reducing weight litttle by little. The sound it makes; priceless!
kavisl 1 month ago
Your rustler hugs the road like there's no tomorrow. Like the new paint job... A+ is my grade..nice job
Johnracerx 1 month ago
@Johnracerx All thanks to you. Followed them to the T. Paint job err main intention was visibility :) didn't clean before painting so came out bad, up close. Well its going to be a long wait for my 35t. Fingers crossed.
kavisl 1 month ago