How To Remove and Re-install a Gearbox & Clutch

[MrJuanDiego121]

Always holding a beer ehy!!! Lmao!!!!

Good video tho

[remtheoneilo]

is it posible to replace a clutch without using a shop lift

[gdrahcir]

@remtheoneilo Do you mean shop lift as in an engine crane or a car shop hoist?? Without a shop car lift but with an engine crane, i'd say it's usually easier to take the engine and box out together from the car, then remove the gearbox and replace the clutch, then put it all back together then back into the car. But without an engine crane it is possible but alot harder. You'd have to jack up the car on stands then put a jack under the box, undo the bolts then slide it off the engine carefully.

[remtheoneilo]

@gdrahcir thanx and do you have a cable clutch or hydraulic clutch

[gdrahcir]

@remtheoneilo This ute in the video is a cable clutch, but i have done a few hydrallic ones too. There aren't any harder. You just have to bleed the fluid through when ya done. Same process as bleeding your breaks.

[remtheoneilo]

drinking a beer drinking a tall glass of vodka and smoking weed while watching this video while changing the trans

[remtheoneilo]

@remtheoneilo trans clutch

[gdrahcir]

@remtheoneilo HAhaha. Love it!!! The only way it should be.

[djlaiguana1]

Hi Buddy, I have a 93 ford Truck E-350 1 Ton Econoline - Van and something happened with the transmission (automatic), full fluid level its OK but when into 1 and 2 .... the truck runs good but for 3rd and 4th the RPMs go up and up (foot on gas accelerating), but the truck doesn't speed up .... i'm stuck on 1st and 2nd...

-Solenoid problem ?

-Should I reset by disconnecting battery ?

-No OD light flashes in dashboard.

-No ''CHECK ENGINE'' light.

Thanks for any help ...

[gdrahcir]

@djlaiguana1 Hi mate. I haven't done alot of automatic transmissions before but to me it sounds like the top gear clutch pack in the box is needing adjustment or replacement. Also the servo band might need adjusting or replacing. We had an auto in a Holden HJ one tunner that had a very similar problem but it was slipping in all gears not just top gear under acceleration. If it is shifting fine then i'm guessing the computer and kick down solidoids are working fine.

[kizza1645]

Pretty fucking tops video

[0171mike]

well done bloody great video in Australian you mob are fuckin classic

do another one!!!

mick from far north qld where it doesnt matter if you cant spell beer just drink the bastard

[Perrowsta]

nice video. thumbs up.

[WOGBOYJZ2]

reminds me of my brother after my other brothers 18th, he was completely smashed but needed to do a service on his car that night before he went away the next. here he is at 11 at night all dizzy and slurring, but as soon as we opened the bonnet, it was like he was sober again haha. when we finished and closed the bonnet, he went back to slurring and falling around. cars have a strange impact on us

[Wazz1152]

Typical Aussie ingenuity, well done guys, even with Hangovers lol