Test of my prototype rigger

[1p90luvr]

thats fuckin fast, 67 mph, on the water! that thang is bitchin, it prolly cost a fortune to built though.

[alexbuneapetru]

pls tell me what motor do you use??

[hurricanefibers]

if you click the more info I give all the spec's on what I am using.

Please check out my other vids

[heatorn]

You need a new wife not a new prop.

LOL

Good job.

[skyliner1991]

do you know what rpm that motor runs at?

buildin my boat just findin electrics hmmmm lol

[hurricanefibers]

check out my other vids you can see this rigger run alot better.

for brushless you multiply the KV by the volts you are putting in and that will give you the rpms.

So for this one 2731kv X 11.1volts =30314 rpm

for feigao motors you want to run them around35000rpm.

[mrfixitwhite]

sorry -found it -just saw the extra info bit!

[mrfixitwhite]

i sympathise- my wifes like that when i fry new ESC's lol

can iask what motor and ESC you run

[hurricanefibers]

I am useing a hitech not the micro the next one up and it is laying on its side cause there is not to much room there LOL

[5Fiend]

What servo are you using?

[hurricanefibers]

ya she just likes to give me a hard time.

it was a grimracer prop thats why it cost so much.

I finaly got my new prop if all go's well I will have a new video of it by the weekend.

[davidnieuwland]

It's fast for sure. You payed 30$ for the prop right. Buy it on Ebay next time , Octura's are like 12 to 15$ on Ebay. Free tip ;-)

Tell your wife that she should be happy with a guy that doesn't go to the bar every night. That will cost far more then 30$ !!

Good job.

[hurricanefibers]

If you watch close at the end of the video you can see my prop leave LOL note to self always check and recheck to make sure everthing is tight.