What a waste all they had to do was restack the stuff. Pulling the bottom pallet out was just not smart and it damaged alot more of the product then what should have been damaged from that.
Idiots! The should have handbombed it. They knew it was going to fall and get damaged. They could have restacked them in about an hour. It wouldnt have been so bad. The stack could have been saved. Haha
rev the engine in neutral with handbrake on and both footbrakes applied 2 lift heavier loads. only works with diesel or lpg dont work with elec forklift
Most of the stuff was perfectly usable until this guy decided to do something about it. I bet he didn´t think about how to defuse this "bomb". If you mess up like this and don´t know what to do you should at least go and get cup of coffee first...distancing yourself from the situation makes it so much easier to find a good way to fix it. I´ve defused some fun bombs myself while being in safety cage.
Idiot is what he is. This all could have been avoided if he had gotten off of the forklift and re wrapped. Second suggestion would have been using the wall to support top skid, place forks to the left and inside of skid, turn steering wheel to the right, backed up and the other three skids would right themselves. Just got to know how the forklift works.
I work in grocery store, ive seen all kinds of mishaps and accidents involving hand jacks, and electric jacks. The worst spill, is a pallet of milk going over, CRASH.
yep, when ya f'up like that dont blame the shrink wrap,or skid,juz get OFF the fork-lift and fix it/re-wrap by hand or else this happens...specially if the product is liquid,or powder as case here.
that was a dumb ass thing to do. coulda save all that product but was to lazy. its funny how people who actually work in a warehouse are more pissed off when watching this then amused. i think we have all had an idiot do this on the job.
The guy on the forklift should have to pay for the damaged product since he has no dam common sense. When something goes down you roll up your sleeves and fix it, not make it worse. 90% of the product could have been saved, now your lucky if you can save 40%. I worked with idiots like this all the time, they dont know when to park the forklift and get their hand dirty.
I have worked with situations like this for years. What this guy did wasn't even an option. This was sheer ignorance on the operators part and it happens all the time.
You have to figure out the best alternative in order to prevent damage to the product even if it means stacking off each loaded pallet on the top to another pallet. Especially bags(sand). What he did was totally unnecessary.
i work in alarge furniture factory and i see this shit happen all the time ...usually end up hand bombing the product and getting a written warning 4 this
I could have manouvered the downed skids to an upright position then removed them from the pile safely and saving the product. Trust me.
2kewl65 11 months ago
Angel dust
TheHuskyGT 11 months ago
if people climbed up and started handballing that it would be a health and safety risk. this was probably the only thing they could do.
drunkolcharlie 1 year ago
id sack someone for that, should have climed up and started stacking it down, save a couple af grand
choppersgun 1 year ago 3
some guys will do anything for overtime
CarlosCoy135 1 year ago 3
Happens
DoctorVince 1 year ago
maybe coulda saved the middle skid.. the top one was done
FNcanucker 1 year ago
What a waste all they had to do was restack the stuff. Pulling the bottom pallet out was just not smart and it damaged alot more of the product then what should have been damaged from that.
darknessrising999 1 year ago 3
Get a new pallet and spend 45 minutes restacking and save Yourself a five hour cleanup and thousands of dollars.
gamezky 1 year ago 3
Was that blow? I've never seen a forklift lay a line of coke before...that's interesting.
gcdcman81 1 year ago
Idiots! The should have handbombed it. They knew it was going to fall and get damaged. They could have restacked them in about an hour. It wouldnt have been so bad. The stack could have been saved. Haha
TheSleepyBeaver 1 year ago
Fail.
sicorange3 2 years ago
I can think of 2 other ways to solve that and save ALL the product. Oh well
tomtheft 2 years ago 11
@tomtheft same think fucks
rabbitfeatures1 1 year ago
@tomtheft And those 2 ways are?
pingpongpung 1 year ago
@tomtheft 2 months to answer and still nothing. It means your talking bullshit.
pingpongpung 1 year ago
LOL, nothing but hate on this one.
theedevious1 2 years ago
Brainless Idiot would he have lifted 4 pallets at once i.e. single pallet lifted with weight of 3 collapse pallets on top if stack was vertical?
Minty9167 2 years ago
he could of easily saved those pallets. I work in a warehouse and i have fixed pallets that no one else could fix with and without a safety cage
soonerfan006 2 years ago
FAIL
dhastie3000 2 years ago
the only option was to handbalm EVERYTHING
jeepdude770 2 years ago
yeah and that way all product would've been saved, but now more than 50 % of it was LOST
VancouverCanucksRock 2 years ago
somebody about to get written up
ryan93280 2 years ago
I like the nice hole in the wall
Gaowyim 2 years ago
rev the engine in neutral with handbrake on and both footbrakes applied 2 lift heavier loads. only works with diesel or lpg dont work with elec forklift
fatfolol 2 years ago
Most of the stuff was perfectly usable until this guy decided to do something about it. I bet he didn´t think about how to defuse this "bomb". If you mess up like this and don´t know what to do you should at least go and get cup of coffee first...distancing yourself from the situation makes it so much easier to find a good way to fix it. I´ve defused some fun bombs myself while being in safety cage.
DarkZodiacZZ 2 years ago
You are retarded for doing that. Go Menards!
ilrailfan 2 years ago
cant belive I live on the same planet as you yanks.
cox325 2 years ago
This happened at Home Depot, that's why Lowe's is so much better!!!!!
cybermatrix24 2 years ago
Idiot is what he is. This all could have been avoided if he had gotten off of the forklift and re wrapped. Second suggestion would have been using the wall to support top skid, place forks to the left and inside of skid, turn steering wheel to the right, backed up and the other three skids would right themselves. Just got to know how the forklift works.
bagobuilder61 2 years ago
Hes an awful idiot.Hes driving with hes leg out the side of the forklift.
maxxxoooo 2 years ago
I work in grocery store, ive seen all kinds of mishaps and accidents involving hand jacks, and electric jacks. The worst spill, is a pallet of milk going over, CRASH.
What a mess i had to clean.....
coopmen 2 years ago
yep. with eggs and red fruit drink. that night sucked for me.
dockarnage 2 years ago
yep, when ya f'up like that dont blame the shrink wrap,or skid,juz get OFF the fork-lift and fix it/re-wrap by hand or else this happens...specially if the product is liquid,or powder as case here.
ThundaLippz 2 years ago
that was a dumb ass thing to do. coulda save all that product but was to lazy. its funny how people who actually work in a warehouse are more pissed off when watching this then amused. i think we have all had an idiot do this on the job.
bruceleroy1973 2 years ago
Now clean it up!!
ben42033 3 years ago
dumbass could of saved some product, but F'ed it up instead. wow
bobert1610 3 years ago
The guy on the forklift should have to pay for the damaged product since he has no dam common sense. When something goes down you roll up your sleeves and fix it, not make it worse. 90% of the product could have been saved, now your lucky if you can save 40%. I worked with idiots like this all the time, they dont know when to park the forklift and get their hand dirty.
Modgoth 3 years ago 2
hahahahaha
fadropblane 3 years ago
I bet whoever STACKED that feels smart.......lol
Falgoose 3 years ago
haha goog job, now let the new kid pile it up. Why having a smart boss is so uncommon?
Frankasti 3 years ago 3
I see this stuff from timke to time at my wharehouse, the idiots who decide to show off and cause accidents
odelgado78 3 years ago
I have worked with situations like this for years. What this guy did wasn't even an option. This was sheer ignorance on the operators part and it happens all the time.
You have to figure out the best alternative in order to prevent damage to the product even if it means stacking off each loaded pallet on the top to another pallet. Especially bags(sand). What he did was totally unnecessary.
Mowac 3 years ago
Yes lets remove the bottom pallet, that will fix it!!!
jigbuilda 3 years ago 3
another dumbass
watchtheshow08 3 years ago
stupid workers heh?
normaly ive stacked it correctly so this wouldnt happen...
stupid workers...
jakstat12 4 years ago
that was bad stacking! always make sure the standing pallet is level before you start stacking,common fuckin sense like.
c1k25 4 years ago
I could have fixed that. ;)
unillenium 4 years ago
me 2
buffaloman1980 3 years ago
me to
TTOIA 3 years ago
coglioneeeeeeeeee
giulioaudi 4 years ago
fucking gravity
btstma123 4 years ago 3
What's in the bags?
Flour?
markpemble 4 years ago
heroin
Mavi222 4 years ago 11
Calcium Carbonate(Limestone)
Splinter3000 4 years ago
i work in alarge furniture factory and i see this shit happen all the time ...usually end up hand bombing the product and getting a written warning 4 this
doogwood 4 years ago
shit happens.take it with a pinch of salt.hahahaha
ironaiden666 5 years ago
Yeah, that sucks. (as in shit all over the floor, not vid)
GadreelRavenstar 5 years ago