Nitro RC Engine Tuning 1 (useing a HPI-Racing Savage 25)

[xXrCrusHeRXx]

240p we meet again.

[SootyHunt]

@xXrCrusHeRXx oldest comment on youtube we meet again.....

[xXrCrusHeRXx]

@SootyHunt Still gets thumbs up (:

[SootyHunt]

@xXrCrusHeRXx and thumbs down ;)

[tobybakerII]

and 210 to 230 is good idk what your talking about

[tobybakerII]

running the motor 250 to 300 will burn the hell out of your engine

[007foppe]

are they have also engine trouble shooting ? my engine do klang klang klang with roto start it gets going but takes time and the engine sound very inregular and shuts of sometimes tuning not helps much it seems but tuning im a noob at -_-

[tooleino]

my savage 25 cuts out when i brake, what should i do

[otrebogad82]

@tooleino my does too,,what do i do? did you find out?

[otrebogad82]

Respond to this video... just like TOOLEINO my savage also cuts off when i brake, what do i do?

[iseeanything]

@otrebogad82 its because your throttle closes when you brake. take your air filter off and look at your carborater. now go and press brake you will see your throttle closes leaving no gap. you need to open it by turning idle screw clockwise until you see a about 2mm gap.

[dmcdermott92]

@HPIracing543 Every time i start my savage it cuts off almost immediately. It worked perfectly when I took it to the hobby shop, but it didn't work when I brought it home. What's wrong with it?

[suzukiholdenman]

I just put a force .25 in a small rc car and I've nearly tuned it, I think it'll do wheelies when i'm done :D

[4264joe]

anyone know the base settings for nitro star s-25 engine for savage

[PJdacoolDJ]

thats weird how u can tune it perfectly but i cant. every time i rev it after tuning my engine starts to stutter and bog down even after i just did 1/8th of a turn i did from base settings :(

[jack4373]

@PJdacoolDJ you got to have your motor hot before you tune it between 250 and 300 is where you want it 275 perfect.

[iseeanything]

@jack4373 i agree, 250 to 300 is right around you want to be. also depending the weather might affect how your engine temperature. people who run 200 to 210 degrees is running to rich which you will lose performance in time. i was telling this to some douchebag on youtube whos running 200 to 210 degrees. also people, run 20 percent fuel dont go over board, running 25 to 30 % fuck up your engine, im sure it give you more power but in time for how long?

[1521joe]

@PJdacoolDJ

got it sorted now?

[TheYamahaarcticcat]

can eny body help me my needlevalve keeps turning in by its self have any idea what to do

[jack4373]

@TheYamahaarcticcat kink the threeds that will keep the needle valve tight.

[TheYamahaarcticcat]

thanks but i already solved it

[kiddo6921]

any one here have the half tank lean problem

[kiddo6921]

look at the stuff on it, the fuel tank is a .21 tank it has a primer, i know my 25 has a little more torque than that! I was just stating an observation

[kiddo6921]

any one else notice this is a .21 not a .25??

also the factory settings for the .25 are flush on both needles according to the manual

[Siggerud3]

@kiddo6921

Why do you think it's a .21? It looks exactly like the engine that came with my savage 25?

[jcbringas67]

thanks banana 746 it was a lot of help the problem now is fixing the suspension cause it got into an accident. But thanks

[jcbringas67]

Got a savage but do not have the settins for carb etc... can anybody help? Thank you

[banana746]

For an s-25 setup, stock settings are (From CLOSED)

HSN 4 and a half turns out

LSN 3 turns out.

It took me donkeys to find that info, I looked everywhere when I slapped an S-25 into my MT2 G3.0 -.-'

Have fun ;)

[joshwaggoner14]

how do i tune my tmaxx 3.3 the guy at the rc shop said he cant get it to tune

[CrzayMazy]

First make sure your carb is closed. This is not always a radio setting, so check the mechanical parts/linkage. If those are ok and the carb is closed, try adjusting your idle. This needle determines the engines idle rpm.

4 Years ago, it happened to me that the linkage was not connected to the carb and it went full-rpm at starting. But I was still a newb back then :P

[4264joe]

can u help me

i have been trying to get my savage ss 25 to work but when i get it on it just races and i cant stop it it just rev uncontrolled what is going on wat are the bas settings for the nitro star s-25???

[boldziga]

stop repeating urself

[PresidentZMAN]

this was the most helpful video ive ever seen in my life. that is no exageration. i just got my savage running at top performance.

[Monkeykid5228]

how do you know how its broken in?

[warranqe]

you don't, the only way is to tell is how long it lasts.

[Monkeykid5228]

thanks.

[warranqe]

you "might" also have difficulty tuning the truck after like half a year lol but yeahh

[Monkeykid5228]

unfortunately, i dont have a nitro... but i think it would be nice to get into for a little more durability and challenge for keeping it upkept. considering i just turned 14 a week ago, i am still trying to get a job...

[warranqe]

LOL YOU are young...!

[Monkeykid5228]

yes, and for some things its good, but for others its bad... like getting a job here is almost impossible.

[WhatAreWeDoingForFun]

can;t get a job til 15 1/2

[Monkeykid5228]

@WhatAreWeDoingForFun theres differences in parts of the world...

[WhatAreWeDoingForFun]

figured after i typed the comment.

[Monkeykid5228]

@WhatAreWeDoingForFun- lol!

[quwn05]

this is very helpful

[preets18]

thanks

[SaltLakeCityUCE]

This Video is mandatory viewing for any new Savage owner. Thank you so much!!!

[AlWheelin]

Thanks, this was awesome helpful!!