Invert Mini Complete Disassembly

[nekonaru16]

I'm guessing you have to disassemble the whole thing in order to change the eye board. Am i right?

[randomstuf54]

so you just need to push out the bolt?

[Towelie58]

@randomstuf54 take out the rear grip frame screw the stick your finger in the breach and push the bolt out if it doesn't pop out when you remove the screw

[Caboose129]

you andy my thing with my lower gas exchange tube oring on it fell out and i dont know how to get it back in and make it stay in.plz respond asap ive already searcched for several hours to diagnose leak

[youngpaintball]

if u can help this would be great the problem is wheneber i put mr air tank on it will push the bolt forword and will leak air out of the trigger any help iv replaced all o rings and lubed it help me out

[Jher2006]

thanks for the video... it helped me out a lot! keep up the good work

[MnNinja29]

I just took my mini apart to clean and lube everything. I thought I did everything right, following the video by invertpaintball. I turned my marker on. The board was working. Then I turned it back on holding the trigger. Didn't hear that clicking sound when pulling the trigger. Put some balls in the breach and it won't fire.

I think it is something with the...solenoid? I don't know.

[awaud55]

check the batteries lol, that could be whats wrong...

[wiilikepie]

Why is the rear retaining screw so tight? It wasn't too hard to unscrew but it was nearly impossible to screw back in.

[CanadaBud420]

can i take my bolt out to clean it without taking the grip frame off?

[AndyYPC]

Yes, just unscrew the rear retaining screw and it just pulls out without the need to remove the grip

[babaganush00]

my feedneck is like impossible to get out.

[airsoftking360]

try heating it wit like a hair drier

[swatsn1per]

whered u get that invert pad?

[obito55]

thanks alot!!! :D really helped