Stan Meyer Water Fuel Cell Test Run #4

[thewonn]

Nice Work...I cant believe i have not seen this vid before....awesome!

Were you pulsing the current into the alt or just straight to the alt? How many volts/amps are going into the alt?

Great replication.

[TheStanMeyerProject]

@thewonn Thank you! There is no PWM. Running about 7V and 1.5A to the alternator from a fully rectified AC signal(60Hz) out of the Variac. So, it would technically be pulsing at and it was measured @ 120Hz. I had a hard time trying to measure signal to the cell from the alternator, which averaged in the KHz ranges. If I remember correctly, each phase measured approximately 1.6 Khz.

[thefencejumperengine]

The sentence should have said "split Nitrogen".

[TheStanMeyerProject]

@thefencejumperengine I understand it's not the easiest to communicate through comments on youtube. I'll try my hardest to comprehend what you are truly trying to write with such small amount of character space. Thanks again for your interest!

[thefencejumperengine]

So what's the status? Do you get more energy out than you put in???

[TheStanMeyerProject]

@thefencejumperengine Status? The demo cell replication was a success but, was never expected, nor, designed with any type of over unity. I have come to the conclusion(so far) that Stan Meyer's tubular demo cell looked as if there was an phenomenal amount of gases with low input power although, the numbers presented throughout all documentation and from my personal experiences, the device barely surpasses Faraday's standard. My interests have shifted towards researching Meyer's injection system

[thefencejumperengine]

@TheStanMeyerProject. But I presume the idea is to get more energy out than what you put in?

[TheStanMeyerProject]

@thefencejumperengine No, the idea is to run an internal combustion engine with primarily water. In my personal opinion, I would call it low energy atomic manipulation or it can go even as far as nuclear. You can not get something for nothing, so, what looks as more out than in can be deceiving while the energy comes from several sources such as atomic or nuclear forces. It is said and written that if unstable Hydrogen and Oxygen atoms associate, thermal energy is released until stabilized.

[thefencejumperengine]

@TheStanMeyerProject. You just meantioned nuclear. Isn't it right that radiation can Nitrogen molecules into 2H2 and O2? I read it somewhere long time ago, but forgot where and have found very little research on it on the net. Concerning splitting water into H and O, unfortunately it takes exactly the same energy to split that what you get out again when assembling atoms to water.

[TheStanMeyerProject]

@thefencejumperengine I'm sorry, I do not understand if you are making three points or one. 1: yes I mentioned nuclear, 2: Radiation can split Nitrogen into Oxygen and Hydrogen? 3: As I see it, it takes more energy to disassociate water with electrolysis than you get back from the combustion of the same two gasses.

What I am researching, is the possibility of highly unstable positively ionized Hydrogen and Oxygen increasing the disassociation of water and thermal output of the combustion.

[ilav1m8y]

I bet you'd never even built a Stanley Meyer Fuel Cell, do you like my little quote thats directly from Stanley Meyers information pack that he'd given to the Maori's in Auckland of New Zealand.

watch?v=jIvDTamdBnQ&feature=ch­annel_video_title

Smell that, thats your "VIC" BULLSHIT, I'd only paid $50.00 for my lm555 square wave frequency generator to dial into my calculated WFC V.1 capacitance calculators resonant frequency. At least you have your "VIC" dreams, ya DUMB ass! You're a LOSER

[TheStanMeyerProject]

@ilav1m8y

I'll take that bet! See the above video, the one you commented on. Now that I have showed you mine, let's see yours.

[LucifersDisciple6]

@ilav1m8y Lets see yours.

Until then be quite inferior being

[ilav1m8y]

The Capacitance is directly proportional to the surface area of the conductor plates and inversely proportional to the separation distance between the plates. Gas production is dependant on the Voltage electric stream as it displaces sustances by accululating (gravitationally) the universal constant under increasingly higher pressure equalibriums. It is the absence of the Amperage magnetic stream to defuse that solidity into tenuity by releasing those higher pressures. The Key= Cold Electricity

[sceptic33]

watch?v=ecdTGc44C5g

[BigguthDickuth]

Ideally, no. Stan did make a water heating device that could heat a home, though. The device strongly resembled a normal hot water radiator, but, the water was heated by his VIC technology.

[maciejwrotek]

can u heat up house with meyers water cell ?

[DonatoThomas]

Be careful about putting HHO under pressure. Especially if releasing the gas quickly. A spark from static electricity can make the whole thing explode in your face.

[TheStanMeyerProject]

@DonatoThomas

Thank you for the advice! Because of the dangers and problems with typical pressurized cells, I have decided to try my hand at building an injector type design. I hope to have some new videos up soon.,

[maciejwrotek]

@DonatoThomas Maybe he could mix it with ambient air, as a moderator, that is how meyer says one can regulate flammability of hydrogen.

[DonatoThomas]

@maciejwrotek The safest way to collect the gas and pressurize it is to only collect the hydrogen.  There is no need to collect and pressurize the oxygen with it. The problems with doing that are more logistics than anything. It starts with the construction on the generator. The anodes and cathodes, or plates, have to be further apart; one positive and the other negative. And the further apart they are, the more current it takes to get the work out of them. Then you add salt . . .

[maciejwrotek]

@DonatoThomas This is voltage field separation method for hydrogen generation i think, so increasing amperage would be counterproductive and would generate losses in a form of heat. Adding electrolyte would contribute to this i think. Perhaps it is better to use distilled water then.

[DonatoThomas]

@maciejwrotek I think you missed the initial point: it is very dangerous to pressurize the mixture of hydrogen and oxygen. But pressurizing just the hydrogen is much safer. And the easiest way to do that is to start by collecting just the hydrogen at the time of creation. By the way, distilled water will not conduct electricity, so you have to add something to act as the electrolyte.

[boyd868b]

so,what do you think?

[TheStanMeyerProject]

@boyd868b

I didn't see anything out of the ordinary. Why do you ask?

[boyd868b]

have you looked at us patent 3980053 ?

[TheStanMeyerProject]

@boyd868b

Yes

[mrgalleria]

Nice system. Good replication.

Maybe no OU, but your well on the way.

[TheStanMeyerProject]

It is a Big Blue 20" Clear Water Filter Housing

[Yarosowah]

Where did you get the tall housing? Very hard to find.

[TheStanMeyerProject]

In this video, I was testing a 24V stator and comparing it to the stock 12V stator. The coils are wound the normal 3 phase "WYE" style. The alternator is also deregulated. The pulley's are 6" and 2". Motor speed is marked as 1725rpm. Measured frequency to the cell is 3.03Khz. Input frequency to the alternator is 120Hz. There is no resonance of any kind with this design. Although, the input power is amazingly very low for this much gas. I hope to have a "Liters Per Minute" video here soon.

[h2opower]

At what RPM did you find resonance with the cell? What is the size of your pullies? And did you wire the alternator in series making it one long coil with the diode at the second to thrid coil connection?

[sirHOAX]

Nice Build.

[valereydyachuk]

I would like to know if there is anyone who had produced the same results as Stan Meyer. He was putting in very little electricity to the water and getting a lot of hydrogen out of it. Please let me know if there is anyone with a working resonant electrolysis device.

[maciejwrotek]

@valereydyachuk that is the idea o voltage water separation, small - half and amper- current

[ddanvos68]

Stanley meyers still produced way more gas! This production seems to be right on , No OU here