Water4Fuel #17 Hydrogen Gas - New Bubbler Flash Back Test Part 2

[CompuTable78]

2:20

[jamesberkhimer]

volt/amp meter's sears sell a good one, so dose radioshack, home depot, lowes, best buy, circut city, or your local electrical supply store.

[HHOhybridBuilder]

install a check valve between the bubbler and the main cell.

[V1perNeo]

If you are still doing this, go back to you're first bubbler and fill it with play sand. It wont blow up.

[jylp4u]

pause at 2:20, see that by the bottle to the right on the desk, what is that?

[jmh11962]

what ever you do,DO NOT increase the diameter

of your bubbler!!!you've got something that works,don't mess with it!increasing the diameter

only increases the volume of(incredibly explosive)gas that can go off!!

[kimballanbits203]

idk y u stoped makin vids but for a flash arestr try takin your bubbler stone and a peice of tubin just larger than it,then fit the tube around the stone and fill it with water if you could get one way valve below the new flash arestor it should work evenbeter.the water will stop your stone from crakin.and you know that the water will work cuz o one of your previous vids were the water was proventin you from testing your bubler.love your design and hope to use it soon on a motorised wheelchair

[rclewis01]

If you have a cheap multimeter that reads milivolts, then just use a 1/4 stainless bolt. The current has to flow through the bolt and you have to put the meter leads exactly 1 inch apart. Then 5 milivolts would be 5 amps. It is just a shunt resistor in this case.

[codemsan]

also consider,the less air space between the cap and the water on your bubbler,the less hydrogen can build up in that space and "go boom":)

[NaturalyUnatural]

Hello have you tried adding a vibration to your cell plats in the sonic rang? Say like that of a sonic tooth brush, my thinking is that it will help keep the bubbles off the plats and allow more production.

[Cherryb85]

assuming hes going to use this in a vehicle of some sort the vibrations could come from that... but thats a good idea

[jeremusic]

realise that without electrolyte you have a HHO mix and not H2 which of course has its own oxygen, if you were producing just H2 you would only get burn at the air contact point

[marthale7]

The caps that you use, what is that part called?

Is that found in the plumbing area? Thanks

[crazzieg]

Wow!! You do have good neighbors. Mine just happens to be the fire department's rescue squad. I think the check valve did work by keeping the back pressure from the cell. Didn't see any electrolite in the hose comming from cell to bubbler. Maybe the check was on the wrong side of the bubbler in your test ?? Good pop, not as good as Sidyoung's HHO powerd 35mm wabbit hunting device.. heheh Try the loops with some water in them on the output side of the bubbler. Keep it up good.

[CarbideTip]

Great videos. Thank you.

Will the air stone restrict flow and plug up at some point? Running in a aquarium they will. You might be unknowingly build up pressure in the cell.

[sidyoung]

Excellent, glad to see that you are using some caution ;-)

[sirHOAX]

Again, Nice work..

That puts out some POP! Atleast you know you have excellent gas being produced.

Regards, --sirHHoAX-- :=P