Easy as shown ! Didn't get his hands dirty. Much more difficult to do whilst shaft is on the vehicle. Everything is dirty. (and awkward). A cone is easy. Nick a cone from roadworks and cut to size !
Easy as shown ! Didn't get his hands dirty. Much more difficult to do whilst shaft is on the vehicle. Everything is dirty. (and awkward). A cone is easy. Nick a cone from roadworks and cut to size !
this is just a bad idea because without spiting the axle apart there is just no way to properly clean the old grease and road contaminates out(thats the important one) and you cannot properly repack the new grease which without splitting the axle. The only thing you need is about an extra 15minutes, a vice and a sludge hammer
@nathansnation A CV boot should be replaced when it is perished, before it splits open and allows road contaminants in. Before our CV tool was available, CV boot replacement was often not cost effective and most boots/joints were left to fail resulting in a higher cost and less environmentally friendly shaft replacements a few months later. By using our CV tool and boots, the life expectancy of a CV joint can be extended considerably. That's good for workshops, customers and our environment.
I guess it helps if you have the right tool...
mandykal 3 weeks ago
thats cheating! lol
wesmath1 1 month ago
Thanks for the upload its good. i have replaced it for my car and charged for £100, is it reasonable or i have overpaid for it.... ..
TheRhino303 3 months ago
Perfect idee.
WildeTanteAnna 4 months ago
This has been flagged as spam show
Easy as shown ! Didn't get his hands dirty. Much more difficult to do whilst shaft is on the vehicle. Everything is dirty. (and awkward). A cone is easy. Nick a cone from roadworks and cut to size !
handsacre1 5 months ago
This has been flagged as spam show
Easy as shown ! Didn't get his hands dirty. Much more difficult to do whilst shaft is on the vehicle. Everything is dirty. (and awkward). A cone is easy. Nick a cone from roadworks and cut to size !
handsacre1 5 months ago
Comment removed
handsacre1 5 months ago
do not show this tool to proctologists :)
vitiay 8 months ago in playlist MECHANIC- DIY 2
Or you could just buy a cone for 5 bucks off ebay which lets the gaiter stretch straight over the driveshaft!
wwwagstaffe 9 months ago
Nice tool. Too bad autozone don't loan them out.
swanz199 9 months ago
cool
hp11208 9 months ago in playlist My Vlog
what if I drove about 30 feet then parked my car and know that's when my cv boot busted. I ripped it while I was putting wheel hub assembly on.
JoeCnNd 9 months ago
this is just a bad idea because without spiting the axle apart there is just no way to properly clean the old grease and road contaminates out(thats the important one) and you cannot properly repack the new grease which without splitting the axle. The only thing you need is about an extra 15minutes, a vice and a sludge hammer
nathansnation 1 year ago
@nathansnation A CV boot should be replaced when it is perished, before it splits open and allows road contaminants in. Before our CV tool was available, CV boot replacement was often not cost effective and most boots/joints were left to fail resulting in a higher cost and less environmentally friendly shaft replacements a few months later. By using our CV tool and boots, the life expectancy of a CV joint can be extended considerably. That's good for workshops, customers and our environment.
ptwtools 1 year ago 5
wish i had that much open space when working on the truck!!!
uluahunta09 1 year ago
thats siiiick! never seen that before it saves mad time with the stretch tool :)
jambe1234567 1 year ago