Mastercam X5 - Comparación - V9 Pocket & X5 Dynamic Mill

[sazarvash]

not quite, no dynamic or troichordial milling on v9...it'd be hard to emulate the toopaths x5 or x4 creates

[sonofsun4]

Well,that is comparing apples and oranges. In MC9 you can do basically same thing by spiraling down to full depth by same routine as X5 and then set the same parameters as X5 cut and you will get very similar result.The difference is only in the fact, that inX5 you cut full depth and in MC9 you step it down,thus obviously loosing time.

In any case, nice vid. Thanks for the time to do it.