Dynam superCub power problem

[TheSnitteren]

I had the same problem. The dealer fixed it. He tol me that I had turned the transmitter on when the trhottle was on full power. That makes the plane go into programming mode, and I must have chosen a wrong setting. He set the thruttle on full, waitet untill 5 double-beeps sounded.

Problem solved!!!!!

[inciteman]

A few of my speed controllers tend to do this too... I think the timing is off so it helps to change it sometimes.

[P1G5CanFly]

@inciteman

So it may be quite a common problem. Nitroplane asked me to send in the motor + controller and they replaced it. Flown this plane a few times and the plane is in a quite beat up state now :)

[zighearts]

Hey I bought almost the same plane, the Dynam cessna. I was not happy with the brushless esc and motor. The esc got way to hot and had to much resistance. I upgraded the esc to a e-flite 20 amp brushless esc and a e-flite park 400 outrunner brushless motor, 920 kv. Now my Dynam cessna has plently of power and long 18 minute flights.

[P1G5CanFly]

I talked to Nitroplanes and they asked me to send in the ESC & motor and they will replace.

May be I should have just replace the ESC with a better one than the stock Dynam ESC after all.