You would not see no Haas mill run a endmill like that. The machine would probly bust in two from vibration. I know ours would. Looks like a great mill if you have a good machine to give it justice.
I cut everything up to the PH SS dry. it's better for the tool/carbide. I recommend it being ran with air blast. If chip evacuation is a problem turn the coolant on.
Cool. Place give a feed and speed parameters.
Thanks. Iscar work with MasterCAM
Zenjoksss 6 months ago
'
cutting aluminuium block is easily than harden steel block
bestamerica 7 months ago
You would not see no Haas mill run a endmill like that. The machine would probly bust in two from vibration. I know ours would. Looks like a great mill if you have a good machine to give it justice.
MrBallistic31 10 months ago
I cut everything up to the PH SS dry. it's better for the tool/carbide. I recommend it being ran with air blast. If chip evacuation is a problem turn the coolant on.
generalleeloaded 1 year ago
Comment removed
SPUNKKK 1 year ago
@SPUNKKK It's all in the coatings.
freefall4fun 1 year ago