@MADJIHAD1942 I've never measured it, but I nearly always do a calibration before cutting for real - I check the sides of a 4" square and enter the values measured into the axis calibration dialog. I can be out by anything up to 0.03" due to extreme heat or cold.
What are the tolerances on that setup? Im just curious since its made out of wood so moisture could throw off the calibration I think?
MADJIHAD1942 5 months ago
@MADJIHAD1942 I've never measured it, but I nearly always do a calibration before cutting for real - I check the sides of a 4" square and enter the values measured into the axis calibration dialog. I can be out by anything up to 0.03" due to extreme heat or cold.
shobley 5 months ago