Bending Conduit Part 4 of 5 (Polly Friendshuh)

[Shawtylovesyux3]

lol at her face!1:08 

[Claretcross]

On Three point saddles for small obstructions of 1" or less I use 22 1/2 on my center bend 10 degrees on the outside. It works well in walls .

[45younglove]

thanks

[bhennessee01]

why dont you take the 5 seconds it takes to screw on your no dog?

[Claretcross]

@bhennessee01 If you were a Wireman you would know that a No Dog doesnt work on a hand Bender.

[bhennessee01]

we almost never run emt but it is really a whole lot easier than this math crap to bend an offset or a four bend.

[Shocksparky]

great video's even though the 4 point saddle sucked. But thanks.... im not the only one who has to adjust there bends.

[whspioneer89]

I noticed this video you included shrink on the A to C bend but the previous video you didn't include the shrink on the second pair bends of the 4 point saddle, bends C-D.

[GypsyMoFoJoe]

Polly pulled a fast one when the leftside offset came up short....;)

[pyrotech8877]

Make sure you stay close to the bender head. You can see the 1/2" emt bowing as you bend your 30 degree offsets. Other than that not bad. Good job. It's nice to show people how easy it really is to bend conduit.

[drassstic]

well your 4 point saddle didnt turn out well because you need to keep your hands as close to the bender shoe as possible

also use a block to show us what we rae bending over..

[TheManofValour]

Hey Poly, you should use actual blocks or something so we can compaire your math and measurements to reality.